Evaluation of surface characteristics of direct composite resins after finishing and polishing using fractal analysis

Background. The variety of polishing systems and tools available for finishing direct composite restorations may perplex the dentist.Objectives. An effect evaluation in one- and multi-step composite polishing tools using model specimens of GC Gradia Direct and 3M ESPE Filtek Ultimate restoratives.Methods. The prepared specimens of GC Gradia Direct and 3M ESPE Filtek Ultimate restorative composites were exposed in laboratory to the Kenda Maximus, Dentsply PoGo, Kagayaki RoundFlex, Shofu Super-Snap, Kagayaki Ensmart Pin, EVE Composoft polishing systems and Daiyamondo Kagayaki paste. The polishing systems distinguished by brand, technical and performance characters.Surface microgeometry in all 16 samples was estimated in the Laboratory of Optical Metrology, Institute of Design and Technology for Scientific Instrument Engineering, Novosibirsk, using a MNP-1 light interferometric nanoprofile microscope and at the shared core facilities of the Research and Education Centre “Nanomaterial Diagnostics and Properties” of Kuban State University, Krasnodar, using a JEOL JSM-7500F scanning electron microscope.Results. Optical profilometry and scanning electron microscopy were used to estimate surface roughness in 16 specimens exposed to polishing for one minute. The polishing tools Kenda Maximus, Dentsply PoGo, Kagayaki RoundFlex, Shofu Super-Snap, Kagayaki Ensmart Pin, EVE Composoft, as well as Daiyamondo Kagayaki paste used in instrumental polishing, revealed a varied performance. Optical profilometry exhibited the GC Gradia Direct and Filtek Ultimate specimens to possess the lowest average roughness in two cases: 1) after multi-step polishing with Kagayaki Ensmart Pin tools with Daiyamondo Kagayaki paste (average roughness corresponded to Sa — 0.214 pm in GC Gradia Direct and Sa — 0.248 pm — in Filtek Ultimate), 2) in application of the Kenda Maximus monopolishing tool (roughness values of Sa — 0.211 and Sa — 0.242 pm, respectively). Surface roughness after multi-step machining with EVE Composoft silicone polishers was average Sa — 0.579 and Sa — 0.549 pm in both samples and was reported the highest. Scanning electron microscopy confirmed the optical profilometry estimates.Conclusion. The assay showed that the specimen machining with a sole Kenda Maximus diamond abrasive tool and several Kagayaki Ensmart Pin silicone polishing heads followed by a Daiyamondo Kagayaki diamond abrasive paste application produced very similar surface roughness values, which were graded the lowest with GC Gradia Direct and 3M ESPE Filtek Ultimate composite samples using scanning electron microscopy and optical profilometry.

show abstract

Evaluation of surface characteristics of direct composite resins after finishing and polishing using fractal analysis

Cited by 2 publications

References 8 publications

Box-Counting Fractal Analysis: A Primer for the Clinician

Box-Counting Fractal Analysis: A Primer for the Clinician

Efficacy of one-step and multi-step polishing systems in finishing direct composite restoration: a non-randomised controlled experimental trial

Contact Info

Product

Resources

About