2019
DOI: 10.1016/j.solener.2019.08.013
|View full text |Cite
|
Sign up to set email alerts
|

Experimental analysis of the influence of the expansion valve opening on the performance of the small size CO2 solar assisted heat pump

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1

Citation Types

1
4
0
1

Year Published

2020
2020
2024
2024

Publication Types

Select...
9

Relationship

1
8

Authors

Journals

citations
Cited by 31 publications
(6 citation statements)
references
References 34 publications
1
4
0
1
Order By: Relevance
“…Finally, a quasidynamic model of the DX-SAHP water heater was performed and showed that, through proper control of the speed of the compressor, it is possible to improve energy efficiency and stability of the DX-SAHP systems. On the contrary, for a smallsize CO 2 DX-SAHP, the results presented in the study by Rabelo et al, [38] which are also compared to previous literature works, show that, for this specific refrigerant, the effect of the opening of the expansion device on electricity consumption of the compressor (and therefore COP of the HP) is negligible. Accordingly, the authors suggest using a static expansion device as a capillary tube, thus reducing the costs of this equipment.…”
Section: Solar Source-space Heating/cooling Distribution Sink and Dir...supporting
confidence: 63%
“…Finally, a quasidynamic model of the DX-SAHP water heater was performed and showed that, through proper control of the speed of the compressor, it is possible to improve energy efficiency and stability of the DX-SAHP systems. On the contrary, for a smallsize CO 2 DX-SAHP, the results presented in the study by Rabelo et al, [38] which are also compared to previous literature works, show that, for this specific refrigerant, the effect of the opening of the expansion device on electricity consumption of the compressor (and therefore COP of the HP) is negligible. Accordingly, the authors suggest using a static expansion device as a capillary tube, thus reducing the costs of this equipment.…”
Section: Solar Source-space Heating/cooling Distribution Sink and Dir...supporting
confidence: 63%
“…Chopra et al, 2021 [52] discovered that coated glass wrapper, taking help of crystalline insulation in the middle of collector and wrapper may be used to reduce the heat loss. Rabela et al, 2019 [53] studied about the influence of wind speed in the best size of solar collector, If wind speed changes from 0 to 9m/s it shows the variation by 0.8% and it was also seen that compressor which shows the excessive COP has the shortest supplant. Vengadesan and Senthil, 2022 [54] studied about the Flat Plate Solar Collector(FPSC) and concluded that the performance depend on the solar energy absorbed by the collector.…”
Section: Flat Plate Collectormentioning
confidence: 99%
“…The results showed that after a variation in the solar radiation, the expansion device needs to act almost immediately to maintain the superheat in the correct value range. In addition, Rabelo et al [23,24] presented two experimental studies with a CO 2 DX-SAHP. In the first one, the authors discussed the influence of water mass flow rate on the performance of the equipment.…”
Section: Introductionmentioning
confidence: 99%