Finite Element Simulation Analysis of Cold Rolling Process for Stainless Steel Tube

Li, Yong Hua; Fan, Tie; Liang, Xifeng

doi:10.4028/www.scientific.net/amm.182-183.1494

Cited by 2 publications

(1 citation statement)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Deng, R., et al [3] established the rim rolling simulation model, used the side guide wheel connecting spring to compress the blank, and optimized the simulation results to improve the engineering applicability. Wang H.L., Li Y.H., et al [4] [5] established the finite element model of rim rolling forming, and focused on the influence of boundary conditions on the simulation results. At the same time, the metal flow and stress-strain distribution in the contact deformation zone are analyzed.…”

Section: Introductionmentioning

confidence: 99%

Simulation Analysis and Optimization of Rolling Process of Steel Rim

Lv¹,

Mao²,

Li³

et al. 2021

WJM

View full text Add to dashboard Cite

In order to solve the problems of rolling forming accuracy and fillet thinning of alloy steel rim, a three-dimensional model of three pass rolling process was established, and the influence of different process parameters on forming quality was analyzed by using the finite element software, and the optimal process parameter combination was obtained. On this basis, the simulation results of wheel rim stress and strain for each pass rolling are analyzed, and the particle tracking technology is introduced to analyze the variation rule of stress in each incremental step. Finally, the simulation and experimental results show that the simulation thickness is basically consistent with the actual thickness, which improves the accuracy of rim rolling forming, and further verifies the correctness of rolling process simulation.

show abstract

Section: Introductionmentioning

confidence: 99%