We report the temperature, magnetic field and time dependences of magnetization in advanced Ba122 superconducting tapes. The sample exhibits a peculiar vortex creep behavior. Below 10 K, the normalized magnetization relaxation rate S=dln(-M)/dln(t) shows a temperature insensitive plateau with a value comparable to that of the low temperature superconductors, which can be explained within the framework of the collective creep theory. It then enters into a second collective creep regime when the temperature increases. Interestingly, the relaxation rate below 20 K tends to saturate with the increasing field. However, it changes to a power law dependence on field at a higher temperature. A vortex phase diagram composed of the collective and the plastic creep regions is concluded. Benefit from the strong grain boundary pinning, the advanced Ba122 superconducting tape has promising potential to be applied not only in liquid helium but also in liquid hydrogen or at the temperature accessible with cryocoolers.PACS numbers: 74.25. Qt, 74.25.Sv, 84.71.Mn Understanding the behavior of vortex matter in a superconductor is vitally important for both basic physics and technological applications. Vortex creep caused by thermal fluctuation introduces measurable dissipation and a reduction of the maximum loss-less current. The scale of the thermal fluctuation is usually parameterized by the dimensionless Ginzburg number Gi∝γ 2 T c 2 λ 4 /ξ 2 , where γ is the anisotropy parameter, T c is the superconducting transition temperature, λ is the penetration depth and ξ is the coherence length. Due to high T c , small ξ and large γ, the thermal fluctuation in cuprates is significant, giving rise to the so-called giant vortex creep [1]. It is thus a major task to reduce the detrimental effect of vortex motion in cuprates by incorporating effective pinning centers. Iron-based superconductors (IBSC), on the contrary, have larger ξ, lower γ, and consequently smaller Gi than that of the cuprates [2]. In combination with their high upper critical field H c2 and moderate T c [3], IBSC are considered as potential candidates in largescale application of superconductivity.After ten years of research and design since the discovery of IBSC, the (Ba/Sr) 0.6 K 0.4 Fe 2 As 2 superconducting tapes fabricated by the powder in tube (PIT) method [4,5] are now the prevalent materials for applied research. Up to now, the critical current density J c (4.2 K, 10 T) of the (Ba/Sr) 0.6 K 0.4 Fe 2 As 2 tape has already surpassed the practical application level [6]. Recently, we optimized the hot pressing method and enhance the transport J c to 1.5×10 5 A/cm 2 at 4.2 K and 10 T [7]. It even retains a J c of 5.4×10 4 A/cm 2 at 20 K and 5 T. It was found that the grain size is only 0.5-1 µm, much smaller than that of the Sr 0.6 K 0.4 Fe 2 As 2 counterpart [8] whose grains are *