Functional Dependence of Laser Power and Layup Speed for Automatic Fibre Placement Temperature Control

Abstract

Automated Fiber Placement (AFP) is a relatively new technology that has revolutionized the production of composite structures in the aerospace and space industries for more than two decades and is nowadays increasingly used in new industries such as the wind energy. Generally, the AFP machine consists of an automatic manipulator (robot) on which a layup head is fixed for laying multiple individual composite strips at once (certainly not excluding the possibility of laying a single wider tape when it comes to Automatic Tape Placement). The layup process is performed on a mandrel or tool with a certain geometric shape. The laying head should at least include a feeder, a cutting mechanism, a compaction mechanism (usually roller) and a certain type of heater (depending on the material type). Conventionally, three types of composite materials are used in combination with AFP technology: continuous fibers reinforced with thermoset resin (usually epoxy resin), same continuous fibers reinforced with thermoplastic resin as well as bonded continuous carbon fibers. Depending on the type of material this technology uses various types of heat sources in order to achieve a good adhesion to the individual fibers that are deposited in the laying process and the pre-laid composite layers. Thermoplastic pre-impregnated material requires high temperature to reach degree of melting of the resin used to achieve complete 'welding' with the previous layers. The melting temperature varies for different materials and ranges from 130°C to 200°C for low melting thermoplastics (such as Polyamide PA and Polypropylene PP), 280°C to 350°C for Polypropylene Sulfide (PPS) up to 400°C - 450oC for Polyether Ether Ketone (PEEK). For more than two decades, hot gas torches have been used for thermoplastic layup - not a very expensive system but very difficult to control. One of the newer sources of heat close to infrared radiation (λ = 0.9-1.1 μm) is diode laser heating. This research presents a simple thermal model of the process which correlates the heater power and the layup speed with the temperature of the heating area. The deposition temperature was measured over a range of heater powers and layup speeds. The experimental data is used to define and validate a thermal model for thermoplastic material used in conjunction with a diode laser: carbon fibre reinforced thermoplastics PEEK. This enables open-loop, speed dependent heater power control, based on defining and programming the speed dependent heater power function in the machine controls. Obtained functional dependency was implemented in the AFP machine control system and tested for production of several plates with different layup angles. The achieved temperature during layup process is monitored on the thermal camera and through several pyrometers.

Detecting residuals at plastic samples to optimize laser cutting processes

“…This is because the transmitted light intensity value is close to the light intensity value of the main sample This issue commonly occurs in black and blue-colored samples. The following are the detailed differences between the two methods mentioned above obtained from this study: The study's findings also demonstrated that each process could only be completed in a single cycle in order to completely remove all residuals, considering the unique properties of each sample plate and the energy required by the laser machine [8]. This can be seen in the…”