High-Q single crystal silicon HARPSS capacitive beam resonators with self-aligned sub-100-nm transduction gaps

Abstract

This paper reports on the fabrication and characterization of high-quality factor (Q) single crystal silicon (SCS) in-plane capacitive beam resonators with sub-100 nm to submicron transduction gaps using the HARPSS process. The resonating element is made of single crystal silicon while the drive and sense electrodes are made of trench-refilled polysilicon, yielding an allsilicon capacitive microresonator. The fabricated SCS resonators are 20-40 m thick and have self-aligned capacitive gaps. Vertical gaps as small as 80 nm in between 20 m thick silicon structures have been demonstrated in this work. A large number of clamped-free and clamped-clamped beam resonators were fabricated. Quality factors as high as 177 000 for a 19 kHz clamped-free beam and 74 000 for an 80 kHz clamped-clamped beam were measured under 1 mtorr vacuum. Clamped-clamped beam resonators were operated at their higher resonance modes (up to the fifth mode); a resonance frequency of 12 MHz was observed for the fifth mode of a clamped-clamped beam with the fundamental mode frequency of 0.91 MHz. Electrostatic tuning characteristics of the resonators have been measured and compared to the theoretical values. The measured Q values of the clamped-clamped beam resonators are within 20% of the fundamental thermoelastic damping limits () obtained from finite element analysis. [950]

Scaling effects for electromagnetic vibrational power generators

“…If it is assumed that the tracking spacing, track width and thickness are equal, then the coil resistance for a single layer, microfabricated coil can be expressed as; (11) For large N, the N 2 and N terms can be neglected. The dependence of the coil resistance on the cube of the number of turns arises in this case, from the fact that the turn cross-sectional area decreases with the number of turns squared, i.e.…”

High-Aspect-Ratio SOI Vibrating Micromechanical Resonators and Filters

“…A number of electrical coupling techniques [6][7][8] for implementation of high-order bandpass filters have been demonstrated with beam resonators [9]. The electrostatic coupling technique [9] can be employed to demonstrate second order IF filters.…”

“…The electrostatic coupling technique [9] can be employed to demonstrate second order IF filters. In this technique, application of different bias voltages to the vibrating body of two resonators separated by a narrow coupling gap generates an electrostatic coupling force.…”

CMOS-MEMS resonator as a signal generator for fully-adiabatic logic circuits

“…Clamping losses to the substrate can be avoided by locating the support at a nodal point of the vibration mode or using impedance-mismatched supports to reflect energy back [16]. Thermoelastic dissipation (heat flow resulting from nonuniform strain) can be reduced by shrinking device size, using stiff, high thermal conductivity materials (Si, diamond) [19] or utilizing modes with uniform compression/expansion [20]. Surface loss mechanisms can be minimized by avoiding layered structures (thin-film interfaces) at surfaces.…”