Holistic Design Approach of a Throttled Surge Tank: The Case of Refurbishment of Gondo High-Head Power Plant in Switzerland

Abstract

In order to increase the installed capacity, the refurbishment of Gondo high-head power plant required a modification of the existing surge tank by installing a throttle at its entrance. In a previous study, the geometry of this throttle was optimized by physical modeling to achieve the target loss coefficients as identified by a transient 1D numerical analysis. This study complements previous analyses by means of 3D numerical modeling using the commercial software ANSYS-CFX 19 R1. Results show that: (i) a 3D computational fluid dynamics (CFD) model predicts sufficiently accurate local head loss coefficients that agree closely with the findings of the physical model; (ii) in contrast to a standard surge tank, the presence of an internal gallery in the surge tank proved to be of insignificant effect on a surge tank equipped with a throttle, as the variations in the section of the tank cause negligible local losses compared to the ones induced by the throttle; (iii) CFD investigations of transient flow regimes revealed that the head loss coefficient of the throttle only varies for flow ratios below 20% of the total flow in the system, without significantly affecting the conclusions of the 1D transient analysis with respect to minimum and maximum water level in the surge tank as well as pressure peaks below the surge tank. This study highlights the importance of examining the characteristics of a hydraulic system from a holistic approach involving hybrid modeling (1D, 3D numerical and physical) backed by calibration as well as validation with in-situ measurements. This results in a more rapid and economic design of throttled surge tanks that makes full use of the advantages associated with each modeling strategy.

Retrofitting of Pressurized Sand Traps in Hydropower Plants

“…A versatile method, 3D CFD simulations, can generate information on various aspects of the pressurized flow, such as for sand trap hydraulics. The selected simulation tool, Ansys CFX, has been applied successfully to several hydraulic structures with pressurized flow [13,14]. An unlined rough walled hydropower tunnel is studied in terms of RANS CFD simulation in [15].…”

Submerged Wall Instead of a Penstock Shutoff Valve—Alternative Protection as Part of a Refurbishment

“…Additional changes of the core hydraulic structures are also needed. An example of such a needed modification is the update of the throttle to ensure the functionality of the surge tank [21][22][23]. The prevention and risk reduction of potential disaster situations are also receiving more and more attention.…”