The variation which persisted in interspecific aneuploids even after one or two generations of backcrossing prevented the morphological distinction of the aneuploids from their diploid sibs. An attempt was made to unmask the effects of aneuploidy by producing aneuploids within the more uniform genetic background of a single species.The procedure to produce trisomics and aneuploids of diploid species was to vegetatively double clones or seed of the species with colchicine, cross the induced tetraploids to diploids to produce triploids, and then cross the triploids to the original diploids. An attempt was made to use the same diploid clone and/or introduction of a species in all successive stages of the procedure in order to obtain as much uniformity as possible. This was largely unsuccessful because self-incompatibility and inbreeding reduced seed set. Seventy-three different tetraploids were obtained from seven species. Tuber treatments were noticeably unsuccessful in producing doubled plants. The two vegetative treatments were most successful and produced 41 different tetraploid clones while 30 doubled plants were obtained from four seed treatments.Morphologically the tetraploids resembled the diploid and there was no noticeable increase in size of leaflets and floral parts in the tetraploid. The average number of chloroplasts in ten pairs of guard cells was a distinctive feature which could efficiently be used in distinguishing the induced tetraploid plants from diploids. The tetraploids were generally less fertile than their diploid counterparts and the majority of them exhibited self-compatibility in comparison to self incompatibility of the diploids.