Influence of Coupling Agent in Mechanical, Physical and Thermal Properties of Polypropylene/Bamboo Fiber Composites: Under Natural Outdoor Aging

Abstract

Researches on thermoplastic composites using natural fiber as reinforcement are increasing, but studies of durability over time are scarce. In this sense the objective of this study is to evaluate changes in the properties of polypropylene/bamboo fiber (PP/BF) composite and the influence of the use of coupling agent (CA) in these composites after natural ageing. The PP/BF (70/30 wt) composites and 3% wt CA (citric acid from natural origin and maleic anhydride grafted polypropylene from petrochemical origin) were prepared by using an internal mixer chamber and then injection-molded. The samples were exposed to natural weathering for a total period of 12 months and characterized before and after exposure. All exposed composites experienced a decrease in their properties, however, the use of CA promoted more stability; in mechanical properties, the composites with CA showed lower loss about 23% in Young′s modulus, 18% in tensile stress at break, and 6% in impact strength. This behavior was similar in thermal and physical properties, the result for the CA of natural origin being similar to that of synthetic origin. These results indicate that the use of a CA may promote higher interaction between the fiber and the polymer. In addition, the CAs of organic origin and synthetic origin exhibited similar responses to natural ageing.

Weathering performance of dyed bamboo fiber composites

“…7d for un-dyed and dyed tissue. Basic brown G dye is suitable for dying bamboo tissue with very small pores ; however, weathering can still be detrimental to the surface of dyed wood tissue (De Lima et al 2020). As shown in Fig.…”

Fabrication, Mechanical Testing and Structural Simulation of Regenerated Cellulose Fabric Elium® Thermoplastic Composite System

“…It is worth noting that higher bio-based fibre mass fraction can be obtained in the composites when using hot compression or resin infusion methods compared to that which can be obtained from an injection moulding technique. This can be a crucial point that needs to be taken into account when the presence of maximum fibre content in the part is important [17][18][19].…”

Functional Elastomeric Copolymer Membranes Designed by Nanoarchitectonics Approach for Methylene Blue Removal

“…In contrast, the presence of maleic anhydride (2 wt%) in the copolymer provided reactive centers for covalent coupling reactions [33,34], and enabling condensation with primary amines [35]. Accordingly, recent reports used the amine/maleic anhydride coupling strategy for assembling a large number of polymer blends [36,37] and composites [38][39][40]. In this work, homobifuctional bisamine linkers were covalently reticulated with maleic anhydride blocks of PSEBMA, yielding elastomeric membranes through amide and imide bonds.…”