Influence of Structural Features of Rotor-Disk Mixers on Dispersion Composition of Emulsions

Laponov, S. V.; Shulaev, N. S.; Ivanov, S. P.; Абуталипова, Е. М.; Mugallimov, F.M.; Khalimov, A. G.; Ибрагимов, И. Г.

doi:10.1007/s10556-019-00552-6

Cited by 3 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…So, for example, electronic profilers of the PRT type LLC Research and Production Center "Intratrubnaya Diagnostics" [2] Therefore, for the diagnosis of the linear part of the pipeline with high flow rates, speed changes (instability of the speed of movement of in-tube flaws) lead to a decrease in the reliability of diagnostic data, and when the speed of the diagnostic devices exceeds 5 m/s, the reliability of diagnostic data can decrease from 30... 50% to complete distortion of information. It is the completeness and reliability of diagnostic data during in-tube diagnostics that make it possible to properly assess the degree of danger of detected pipeline defects, which makes it possible to objectively determine the technical condition of the pipeline and ensure its safe operation.…”

Section: Resultsmentioning

confidence: 99%

Problems of safe operation of pipelines with high flow rates of the pumped product and the main solutions

Nuriddinov

Mugallimov

Mugallimov³

et al. 2022

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

The process of cleaning and diagnostics of pipelines with high flow rates of the pumped product causes some difficulties due to the uncontrolled increase in the speed of the in-line device, and as a result, such sharp changes in speed lead to the loss of diagnostic data in many sections of the pipeline, cleaning is performed with less efficiency. This article discusses in detail the problems of operating pipelines with high flow rates of the pumped product and the main solutions. The problems of uneven movement of in-line devices in pipelines with high flow rates are considered in more detail. Special attention is paid to the problems of experience in the operation and use of in-line diagnostic devices in Russia and abroad. The process of cleaning and diagnostics of pipelines with high flow rates of the pumped product causes some difficulties due to the uncontrolled increase in the speed of the in-line device, and as a result, such sharp changes in speed lead to the loss of diagnostic data in many sections of the pipeline, cleaning is performed with less efficiency. Possible solutions to these problems are described in detail, such as: the correct choice of the in-line device used, bypassing part of the pumped product through bypass holes, reducing the volume of pumping of the transported product during cleaning and in-line diagnostics, creating back pressure at the end of the pipeline.

show abstract

Section: Resultsmentioning

confidence: 99%

Problems of safe operation of pipelines with high flow rates of the pumped product and the main solutions

Nuriddinov

Mugallimov

Mugallimov³

et al. 2022

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

show abstract

Development of a design of the mixer for an intensification of chemical and technological processes in the industry

Boev

Afanasenko

Boeva

2020

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

From all variety of instrument registration of processes of hashing for an intensification of chemical and technological processes in the industry small-volume rotor mixers and dispersers with disk actions even more often find application. In this article the design of the small-volume mixer for receiving heterogeneous mixes is described. Constructive design of the device allows to carry out efficiently processing of homogeneous and heterogeneous mixtures.

show abstract

Determination the capacity of low volume mixers for processing liquid environment

Boev

Afanasenko

Boeva

2020

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

The current state of science and technology requires an increase in the productivity of chemical and oil refining enterprises without increasing the overall dimensions of the main technological equipment, as well as the development of fundamentally new devices capable of intensifying the main heat and mass exchange processes. At the same time, new technological equipment in order to ensure energy-saving operating modes needs to determine dependence of design parameters of the apparatus and properties of the processed medium on power consumption.

show abstract

Influence of Structural Features of Rotor-Disk Mixers on Dispersion Composition of Emulsions

Cited by 3 publications

References 0 publications

Problems of safe operation of pipelines with high flow rates of the pumped product and the main solutions

Problems of safe operation of pipelines with high flow rates of the pumped product and the main solutions

Development of a design of the mixer for an intensification of chemical and technological processes in the industry

Determination the capacity of low volume mixers for processing liquid environment

Contact Info

Product

Resources

About