Innovative Design of Residual Stress and Strain Distributions for Analyzing the Hydrogen Embrittlement Phenomenon in Metallic Materials

Abstract

Round-notched samples are commonly used for testing the susceptibility to hydrogen embrittlement (HE) of metallic materials. Hydrogen diffusion is influenced by the stress and strain states generated during testing. This state causes hydrogen-assisted micro-damage leading to failure that is due to HE. In this study, it is assumed that hydrogen diffusion can be controlled by modifying such residual stress and strain fields. Thus, the selection of the notch geometry to be used in the experiments becomes a key task. In this paper, different HE behaviors are analyzed in terms of the stress and strain fields obtained under diverse loading conditions (un-preloaded and preloaded causing residual stress and strains) in different notch geometries (shallow notches and deep notches). To achieve this goal, two uncoupled finite element (FE) simulations were carried out: (i) a simulation by FE of the loading sequences applied in the notched geometries for revealing the stress and strain states and (ii) a simulation of hydrogen diffusion assisted by stress and strain, for estimating the hydrogen distributions. According to results, hydrogen accumulation in shallow notches is heavily localized close to the wire surface, whereas for deep notches, hydrogen is more uniformly distributed. The residual stress and plastic strains generated by the applied preload localize maximum hydrogen concentration at deeper points than un-preloaded cases. As results, four different scenarios are established for estimating “a la carte” the HE susceptibility of pearlitic steels just combining two notch depths and the residual stress and strain caused by a preload.

Simultaneous Enhancement of Strength and Sulfide Stress Cracking Resistance of Hot-Rolled Pressure Vessel Steel Q345 via a Quenching and Tempering Treatment

“…Another important factor for triggering SSC failure is residual stress [33][34][35], which is closely related to the plastic deformation accompanied by phase transformation. A Kernel average misorientation (KAM) map of the EBSD that reveals local misorientation and the strain energy may be used to estimate the stress distribution [36][37][38].…”

Local Hydrogen Measurements in Multi-Phase Steel C60E by Means of Electrochemical Microcapillary Cell Technique

“…Grain boundary diffusion is significantly faster than bulk diffusion, which could result in higher readings during microcapillary cell measurements. In addition, it is well known that residual stress impacts both the local hydrogen accumulation and therefore hydrogen concentration [73] as well as the local hydrogen diffusion coefficient [74] within the material. This directly translates to the results gained by microcapillary measurements.…”

Response of hydrogen charging diffusion of the austenitic stainless steel AISI 310s

“…Various materials are used for the construction of motors, depending on the requirements of the characteristics of the elements and the working conditions of the motor [7,[20][21][22]25]. One of the groups of materials used due to their high strength and corrosion resistance are austenitic steels.…”