Invisibility and indistinguishability in structural damage tomography

Abstract

Structural damage tomography (SDT) uses full-field or distributed measurements collected from sensors or self-sensing materials to reconstruct quantitative images of potential damage in structures, such as civil structures, automobiles, aircraft, etc. In approximately the past ten years, SDT has increased in popularity due to significant gains in computing power, improvements in sensor quality, and increases in measurement device sensitivity. Nonetheless, from a mathematical standpoint, SDT remains challenging because the reconstruction problems are usually nonlinear and ill-posed. Inasmuch, the ability to reliably reconstruct or detect damage using SDT is seldom guaranteed due to factors such as noise, modeling errors, low sensor quality, and more. As such, damage processes may be rendered invisible due to data indistinguishability. In this paper we identify and address key physical, mathematical, and practical factors that may result in invisible structural damage. Demonstrations of damage invisibility and data indistinguishability in SDT are provided using experimental data generated from a damaged reinforced concrete beam.

Special Feature on Nondestructive Evaluation of Materials

“…Damage invisibility and data indistinguishability in the context of structural damage tomography is explored by Smyl and Liu [9].…”

Structural health and condition monitoring via electrical impedance tomography in self-sensing materials: a review

“…On the other hand, when the sampling frequency is high, the aim is usually to maximize the information contained in a small number of measurements. In cases where there is insufficient information, reconstruction quality can be poor and/or measurements may be below the threshold required for distinguishing a change in conductivity relative to a previous state [208]. These experimental realities eventually lead to the following realizations: (i) When the measuring time and the number of measurements are restricted, measurement information should be maximized.…”

A regularization method based on level-sets for the problem of crack detection from electrical measurements

“…This inverse problem is related to non-destructive testing and finds application in techniques used in the science and technology industry, e.g. [3,8,16,20,21,25,33] and references therein. In contrast to elastic materials [8,32], crack identification in the electromagnetic medium is considered in the setting of inverse scattering (see, e.g.…”