Mining Stress Distribution and Fault-Slip Behavior: A Case Study of Fault-Influenced Longwall Coal Mining

Abstract

It is well accepted that faults have significant impacts on the safe production of underground coal mines; however, the fault-slip mechanism during longwall mining through a fault still needs to be investigated. In this study, the distribution of microseismicity events during panel mining through a fault is analyzed, and 3-dimensional fast Lagrangian analysis of continua was used to study the mining stress distribution and fault-slip behavior under the two different mining directions, i.e., mining the panel through the fault from the footwall, or mining the panel through the fault from the hanging wall. The research shows that when the panel is mined through the fault from the footwall, the shear displacement of the fault is significantly greater than those created by mining the panel through the fault from the hanging wall. Under the two mining directions, the variation behaviors of the normal stress and shear stress on the fault are quite different, and fault-slips mainly occur in fault areas where the normal stress decreases. When mining the panel through the fault from the footwall, the slip mainly occurs in the coal-seam roof fault, and when mining the panel through the fault from the hanging wall, the slip mainly occurs in the coal-seam floor fault. According to the variations in the normal stress and shear stress of the fault during the period of mining the panel through the fault, the mechanism of the fault slip can be divided into three categories. 1: Normal stress and shear stress decrease abruptly, but the reduction of the normal stress is greater than that of the shear stress. 2: The normal stress is continuously reduced, the shear strength of the fault is decreased, and the shear stress is suddenly increased. 3: Both the normal stress and the shear stress increase, but the increase in the shear stress is greater than that of the normal stress. These research results can provide a reference for the layout of panels and for fault-slip-induced disaster prevention under similar conditions.

Study on the Pressure-Bearing Law of Backfilling Material Based on Three-Stage Strip Backfilling Mining

“…The SBM technology is, thus, a potential solution to the above challenges.In recent years, research on strip backfilling mining of small and medium-sized mines in China's northern Shaanxi province has been gradually increasing [16][17][18][19][20][21]. Several scholars have studied the stability of coal pillars and overburden in SBM [22][23][24][25]. Zhang et al, among others, put forward the concept of green mining technology for "mining, selecting, and filling + X" in coal mines [26], which provided strong technical support for the so-called green coal mining.…”

Numerical Simulation of Mining‐Induced Stress Evolution and Fault Slip Behavior in Deep Mining

“…e farther away from the coal seam, the earlier the stress change starts. e change of shear stress is mainly increased, while the change of normal stress is mainly decreased, and the change of shear stress is earlier and greater than that of normal stress; the response of shear stress to mining is more sensitive [21][22][23][24].…”

The Mechanical Criterion of Activation and Instability of Normal Fault Induced by the Movement of Key Stratum and Its Disaster‐Causing Mechanism of Rockburst in the Hanging Wall Mining

“…In 2017, the total global coal production reached 5.481 billion tons, with a year-on-year increase of 3.4% and a sustained growth trend [2,3]. In the same year, China's coal production reached 2.541 billion tons, accounting for 46.4% of the total global coal production, ranking first in the world [4,5]. It can be seen that in a long period, coal resources will act as the most important basic energy in China's energy consumption structure.…”