Modeling, design & characterization of a novel Passive Variable Stiffness Joint (pVSJ)

Abstract

In this paper we present the design and characterization of a novel Passive Variable Stiffness Joint (pVSJ). pVSJ is the proof of concept of a passive revolute joint with controllable variable stiffness. The current design is intended to be a bench-test for future development towards applications in haptic teleoperation purposed exoskeletons. The main feature of the pVSJ is its capability of varying the stiffness with infinite range based on a simple mechanical system. Moreover, the joint can rotate freely at the zero stiffness case without any limitation. The stiffness varying mechanism consists of two torsional springs, mounted with an offset from the pVSJ rotation center and coupled with the joint shaft by an idle roller. The position of the roller between the pVSJ rotation center and the spring's center is controlled by a linear sliding actuator fitted on the chassis of the joint. The variation of the output stiffness is obtained by changing the distance from the roller-springs contact point to the joint rotation center (effective arm). If this effective arm is null, the stiffness of the joint will be zero. The stiffness increases to reach high stiffness values when the effective arm approaches its maximum value, bringing the roller close to the torsional springs' center. The experimental results matched with the physical-based modeling of the pVSJ in terms of stiffness variation curve, stiffness dependency upon the springs' elasticity, joint deflection and the spring's deflection

Modeling, Simulation and Proof-of-Concept of an Augmentation Ankle Exoskeleton with a Manually-Selected Variable Stiffness Mechanism

“…The system utilizes a lever mechanism with discrete lever arm lengths. The lever arm mechanism and the discrete variable stiffness actuators have been used in our previous passive exoskeleton design [13][14][15]. The paper is organized as follows: In section 2, the concept and the modeling of the variable stiffness mechanism is proposed.…”

A Variable Stiffness Robotic Probe for Soft Tissue Palpation

“…Unfortunately, this model, commonly used for describing the stiffness of a torsional spring made with a beam [22], is not accurate enough to describe the real behavior observed experimentally (cf. section V).…”

“…Active length of the lever As for most of the VLM mechanisms described in the literature, Awad et al proposed the pVSJ, a variable stiffness joint with a variable lever mechanism which applies forces on two springs [22] (torsional in that particular case). The pVSJ has a large range of stiffness (theoretically from 0 Nm/rad to more than 1000 Nm/rad) for a variable lever length from 0 mm to 30 mm, but the design approach does not allow miniaturization to a human finger size.…”

A Design and Modeling of the Bionic Variable Stiffness Unit Based on the Elbow Joint

“…In PVSJ [16] and TSA [17] change the stiffness of joints by changing the position of the force points on the torsion springs. This method has a large range of stiffness adjustment, but the space utilization rate is low.…”