Monitoring and control of the micro wire-EDM process

Yan, Mu-Tian; Chien, Hsing-Tsung

doi:10.1016/j.ijmachtools.2006.02.006

Cited by 49 publications

(11 citation statements)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It solved adaptive control optimization problem for WEDM. In addition, M. T. Yan developed pulse identification and control system for micro WEDM [20]. The gap state of micro EDM was divided into four kinds, open circuit, spark, arc and short circuit.…”

Section: State Of the Art In Intelligent Adaptive Control Technology mentioning

confidence: 99%

State of the art in intelligent adaptive energy-saving pulse power technology of WEDM

2017

The 3rd International Conference on Intelligent Energy and Power Systems (IEPS 2017)

View full text Add to dashboard Cite

Pulse power as the heart of wire electrical discharge machining (WEDM) tool determines machining quality, machining accuracy, processing efficiency, wire electrode wear, stability of machining process and energy utilization rate of WEDM. For low energy utilization rate and low automation degree of pulse power, this paper systematically analyzed the development of energy-saving technology and intelligent adaptive control technology of pulse power and pointed out its key development direction.

show abstract

Section: State Of the Art In Intelligent Adaptive Control Technology mentioning

confidence: 99%

State of the art in intelligent adaptive energy-saving pulse power technology of WEDM

2017

The 3rd International Conference on Intelligent Energy and Power Systems (IEPS 2017)

View full text Add to dashboard Cite

show abstract

“…A recent yet popular method used for pulse discrimination in EDM machines nowadays is based on an ignition delay timing algorithm presented in (Chang, 2007;Hsue and Chung, 2010;Liao and Woo, 1997;Yan and Chien, 2007) and henceforward called delay time-based pulse discrimination. In this method, a number of pulse trains, each FIGURE 2 Common waveforms corresponding to various pulse types, considering pulses with short ignition delay time as arc pulses.…”

Section: Pulse Discrimination For Electrical Discharge Machining 295mentioning

confidence: 99%

Pulse Discrimination for Electrical Discharge Machining With Rotating Electrode

Tee

Hosseinnezhad

Brandt

et al. 2013

Machining Science and Technology

View full text Add to dashboard Cite

“…Therefore, it is very important to develop a monitoring technique to classify various EDM pulses. Several well-known monitoring techniques including a transistor-controlled power supply [3], short-time-Fourier-transform [4], an emitted radio frequency analyserand a data dependent system modelling analyser [5,6] have been reported in the EDM literature. These monitoring techniques use the preset and classifying various EDM pulses.…”

Section: Introductionmentioning

confidence: 99%