Nb2AlC MAX phase synthesis by SHS metallurgy

Abstract

A cast material based on the Nb2AlC MAX phase was obtained by SHS metallurgy. Synthesis was carried out from the Nb2O5– Al–C mixture with a high-energy CaO2–Al additive. Thermodynamic calculation results correlate well with experimental data. It was found that the CaO2–Al additive content has a substantial effect on the thermodynamic parameters and phase composition of the final product. It was shown that synthesis from the specified mixtures passed in a stationary mode with steady combustion wave. Increasing the additive content leads to increasing combustion rate (from 6 to 12 mm/s), and product yield to ingot increases (from 30 to 47 %) up to 15 wt.% of the additive and then decreases. Variation in the composition of initial mixtures can provide a significant impact on both synthesis parameters and final product phase composition. Optimal conditions of material synthesis to ensure maximum yield of the Nb2AlC MAX phase in the ingot composition were determined. The liquid phase lifetime during synthesis is a determining factor influencing the Nb2AlC content in the final product. It is shown that the maximum Nb2AlC phase amount (67 wt.%) is reached with 15 wt.% of the high-energy additive in the initial charge.

Comparative investigation of ultrafast thermal shock of Ti3AlC2 ceramic in water and air

“…Among the MAX phase materials, Ti 3 AlC 2 is one of the most representative phases, which was synthesized by Pietzka et al for the first time 12‐14 . It possesses an unusual combination of the properties of both ceramics and metals, including high chemical stability, excellent oxidation resistance, good electrical and thermal conductivities, high fracture toughness, high elastic modulus, and good machinability 14‐21 22‐24 …”