Novel polymeric support materials for jetting based additive manufacturing processes

Abstract

PurposeJetting‐based additive manufacturing processes are gaining attention due to their high speed of operation, accuracy and resolution. Support material plays an important role in the additive manufacturing of parts by using processes that utilise jetting (inkjet) technology. This research aims to present novel support material compositions consisting of methylcellulose (MC) and propylene glycol or butylene glycol. These compositions form gels which are easy to remove and provide the advantage of reusability.Design/methodology/approachMC was mixed in propylene glycol or butylene glycol in different concentrations and examined for gel formation on heating and subsequent cooling. The viscosity and surface tension of these compositions were measured at temperatures suitable for jetting. Gel strength was characterised using texture analysis.FindingsThe viscosity and surface tension values at elevated temperatures (i.e. 800°C) show the suitability of these compositions for jetting‐based additive manufacturing processes. Due to their softness, these gels can be removed easily and their low melting points (i.e. near 500°C) allow their reusability as support materials.Practical implicationsThis paper provides a novel approach of using polymer gels as support materials for additive manufacturing processes. These gels are easy to prepare and enhance the sustainability due to their reusability.Originality/valueAlthough, MC in water have shown to form gels and these aqueous gels have been used in many applications such as medicine and food industries, the compositions presented in this paper are unique. Such combinations of MC and non‐aqueous solvents (i.e. propylene glycol and butylene glycol) have not been discussed before and provide an early step towards a new application area (i.e. additive manufacturing) for these gels.

Laboratory workflow to obtain long‐term injected resin composite interim restorations from an additive manufactured esthetic diagnostic template

“…Alharbi et al reported that materials printed vertically (90°) had higher compressive strength that the ones printed horizontally (0°). Osman et al showed that using direct light processing technologies, the recommended build angle for 3D printed restorations was 135°, which may require the use of supportive structures . Tahayeri et al also showed the importance of printing orientation, but they included resin color setting as an important factor for printing accuracy.…”

“…In the early 1980s, computer‐aided design/computer‐assisted manufacturing (CAD/CAM) technologies were introduced in dentistry . The CAD/CAM workflow involves 3 fundamental steps: (1) data acquisition, (2) data processing, and (3) the manufacturing process …”

Additive Manufacturing Technologies Used for Processing Polymers: Current Status and Potential Application in Prosthetic Dentistry

“…The UV‐curable polymers are applied only where desired for the virtual design and, since multiple print nozzles can be used, the supporting material is co‐deposited. Moreover, different variations in color or building materials with different properties can be designated, including the formation or structures with spatially graded properties (Fig ) …”

A review on chemical composition, mechanical properties, and manufacturing work flow of additively manufactured current polymers for interim dental restorations

“…The UV‐curable polymers are applied only where desired for the virtual design and, because multiple print nozzles can be used, the supporting material is co‐deposited. In addition, different variations in color or building material can be designated, including spatially graded structures (Figure ) …”

“…The digital workflow to manufacture a provisional restoration (Figure ) with a 3D printer consists of the following sequence: data acquisition, data processing, and manufacturing procedures Data acquisition involves digitization procedures normally performed by an extraoral or intraoral scanning device, in which the patient's mouth or the working casts are converted into a standard tessellation language (STL) file. Data processing involves the virtual design of the provisional restoration using specific CAD software.…”