Numerical Analysis of Mechanical Energy Dissipation for an Axial-Flow Pump Based on Entropy Generation Theory

Abstract

Mechanical energy dissipation is a major problem affecting hydraulic machinery especially under partial-load conditions. Owing to limitations of traditional methods in evaluating mechanical energy dissipation, entropy generation theory is introduced to study mechanical energy dissipation with varying discharge and tip clearance intuitively through numerical simulations in an axial-flow pump. Results show that the impeller and diffuser are the main domains of mechanical energy dissipation, respectively accounting for 35.32%–55.51% and 32.61%–20.42% of mechanical energy dissipation throughout the flow passage. The mechanical energy dissipation of the impeller has a strong relation with the hump characteristic and becomes increasingly important with decreasing discharge. Areas of high turbulent dissipation in the impeller are mainly concentrated near the blades’ suction sides, and these regions, especially areas near the shroud, extend with decreasing discharge. When the pump enters the hump region, the distributions of turbulent dissipation near the shroud become disordered and expand towards the impeller’s inlet side. Unstable flows, like flow separation and vortices, near the blades’ suction sides lead to the high turbulent dissipation in the impeller and hump characteristic. Turbulent dissipation at the tip decreases from the blade leading edge to trailing edge, and regions of high dissipation distribute near the leading edge of the blade tip side. An increase in tip clearance for the same discharge mainly increases areas of high turbulent dissipation near the shroud and at the tip of the impeller, finally reducing pump performance.

Performance and Exergy Transfer Analysis of Heat Exchangers with Graphene Nanofluids in Seawater Source Marine Heat Pump System

“…Sun et al [25] studied a shell-and-tube heat exchanger with inclined three-lobed baffles, numerically simulated its flow and heat transfer characteristics, and analyzed the structure using heat transfer coefficients and pressure drops. Shen et al [26] considered the limitations of traditional methods in the evaluation of mechanical energy dissipation, introduced the theory of entropy production, and intuitively studied the mechanical energy dissipation of variable flow and blade tip clearance through numerical simulation of axial flow pumps. Preißinger et al [27] studied the design of ORC systems, the selection of working fluids and the matching of heat sources and heat sink temperatures from the perspective of thermal economics, and developed ORC thermoeconomic models based on complexity parameters and structural dimensions.…”

Energy Characteristics of Full Tubular Pump Device with Different Backflow Clearances Based on Entropy Production

“…In this study, the working medium inside the pump was set as constant temperature and incompressible flow fluid [27][28][29]. Therefore, the time-averaged entropy production in the pump only results from Φ T which can be calculated as follows [18,19]:…”

“…In the research field of BTC, entropy production theory can better reveal the mechanism of energy losses due to TLV. For instance, Ji [28] and Shen [29] used the entropy production theory to analyze the energy characteristics under different BTC of a mixed flow pump and axial flow pump, respectively. The results shown that the increase of tip clearance radius led to the increase of energy losses and the decrease of hydraulic performance.…”

Characteristics of the Waviness End-Face Mechanical Seal in Reactor Coolant Pump Considering the Viscosity-Temperature Effect

“…Therefore, to simulate the temperature field, the energy equation including the dissipation item should be considered as in Eq. 5 (Shen et al, 2019):…”