Optimization of Mild Steel Welding Process Parameters Using Multivariate Linear Regression

Abstract

Local welders in Nigeria are prone to poor quality weldment because of their lack of welding technical skills. When these local welders carry out their welding operation, the welded joints are considered to be good enough because the metal materials welded together are seen to be good and satisfactory. In most case, when these welded joints have not fully served their service life, these materials fail due to the poor quality of the weldment. Material quality can easily be assessed by inspecting the microstructure of the weldment. In this wok, mild steel welding process parameters were optimized using multivariate linear regression (MLR). The study involves the determination of the suitable set of conditions for the welding process parameters that would give the optimum weld of mild steel (low carbon steel) using Gas Metal Arc welding (GMAW) technique and obtain a relationship between the three welding process parameters and the ultimate tensile strength and Brinell hardness number. For this reason, an experimental study was carried out using nine samples of the specimen of mild steel. The experimental and predicted results show that arc voltage and gas flow rate affect the ultimate tensile strength and the Brinell hardness number of mild steel. The maximum ultimate tensile strength and Brinell hardness number were Odinikuku et al.; JERR, 10(2): 43-50, 2020; Article no.JERR.54101 44 obtained at 180A, 15V and 20l/min. It was also observed that the ultimate tensile strength decreases with increases in arc voltage and gas flow rate. But these two parameters tend to have a positive effect on the Brinell hardness number. Original Research Article