This paper has established the dependence of the effectiveness of the reverse-osmotic low-pressure membranes Filmtec TW30-1812-50 on the initial concentrations of sulfate and sodium chloride in the range of 20–1000 mg/dm3 at the degrees of permeate selection of 1–90 % with the use of pressure of 3.6–10.0 atm. The dynamics of increasing the content of sulfates and chlorides in concentrates with an increase in the degree of permeate selection, selectivity, productivity, and filtration coefficient of the membrane have been determined. The conditions for calculating the membrane performance depending on the working pressure for sodium sulfate and sodium chloride have been defined.
It is shown that the concentrations of sulfates and chlorides in permeates depend on their initial concentration in solutions and increase both with an increase in the initial concentration and with an increase in the degree of permeate selection. The latter factor is quite significant at the initial concentrations of chlorides and sulfates at a concentration of 1000 mg/dm3. The productivity of the membrane increases with a decrease in the salt content in water and decreases as the degree of permeate selection increases, which leads to an increase in the concentration of salts in the premembrane space.
The selectivity of the membrane increases with increasing concentration of sodium sulfate and sodium chloride solutions in solutions, despite a certain increase in salt concentrations in permeates. For solutions of Na2SO4 and NaCl (20–1000 mg/dm3) at their reverse-osmotic desalting on the membrane, the filtration coefficients have constant values. For these initial concentrations, the filtration coefficient for Na2SO4 is 3.4–3.8 dm3/(m2∙atm), and for NaCl – 2.6–3.2 dm3/(m2∙atm). The data reported here allow us to conclude about the permissible level of mineralization, at which it is advisable to use reverse-osmotic low-pressure membranes. It is shown that an increase in the concentration of salts in concentrates leads to an increase in osmotic and working pressures