Pengaruh Suhu dan Waktu Maserasi terhadap Karakteristik Ekstrak Daun Bidara (Ziziphus mauritiana L.) sebagai Sumber Saponin

Abstract

Bidara (Ziziphus mauritiana L.) is one of the most natural ingredients that has the potential as a source of saponins. Saponins can be used as a natural surfactant which can replace the synthesis surfactant. The purposes of this research were to determine the effect of temperature and time of maceration on the characteristics of bidara leaf extract (Ziziphus mauritiana L.) and to obtain the best maceration temperature and time in producing the bidara leaf extract (Ziziphus mauritiana L.) as a source of saponins. This research is using randomized block design with two factors. The first factor is the maceration temperature which consists of 3 levels, namely 29±1°C, 40±2°C, and 50±2°C. The second factor is the maceration time which consists of 3 levels, namely 36 hours, 48 hours, and 60 hours. Each treatment is grouped into 2 based on the time of implementation so obtained 18 units. The results showed that treatment of temperature and maceration time and interaction between the treatment were had very significant on the yield, crude saponins levels, and the height of bidara leaf extract foam (Ziziphus mauritiana L.) as the source of saponins. Temperature of 50±2°C and maceration time of 48 hours is the best treatment to produce bidara leaf extract (Ziziphus mauritiana L.) as a source of saponin with a yield characteristic of 42.59±0.02%, crude saponin levels of 40.84±0.09% and foam height 29.03±0.38 mm.
 Keywords: Ziziphus mauritiana L., saponins, extraction, temperature, maceration time

Effect of Time Variation on Chlorophyll Concentration in Cocoa Leaf Extraction using the UAE (Ultrasonic Assisted Extraction) Method

“…The response of total chlorophyll concentration indicates that the greater the time used, the total chlorophyll concentration will increase. These results are consistent, that the longer the use of extraction time and the optimum limit is exceeded, it will change the compound structure, because of the oxidation process, so that less extract is produced [24]. This was caused by the oxidation of the extracted bioactive compounds, but if the time used was too little the active compounds will not being fully extracted [25].…”

Analysis of Chemical and Physical Properties of Boiling Time in Kecombrang Drink (Etlingera Elatior, Jack)

“…Based on the study results in Table 2, it shows a significant difference, namely the saponin content of kecombrang drink with a boiling time of 25 minutes the value is 262.19 mg/l, while the saponin content of kecombrang drink with a boiling time of 15 minutes is 178.01 mg/l. Saponins are water-soluble chemicals that are highly soluble in both cold and hot water [16]. The saponin concentration of the kecombrang drink with a 25-minute boiling time was higher than the saponin content of the kecombrang drink with a 15-minute boiling time.…”

“…The greater the temperature, the faster the particles travel to the solvent since temperature influences the mass transfer value. As the temperature rises, the cell movement weakens, making it easier for water, as a solvent, to extract the active component in the material, resulting in a larger yield [16] [17].…”

Formulasi Dan Evaluasi Gel Antijerawat Ekstrak Etanol Kulit Pisang Ambon Lumut (Musa Acuminata Colla ) Dengan Variasi Konsentrasi Cmc- Na Sebagai Gelling Agent

“…Hasil rendemen tersebut sesuai dengan literatur, dimana hasil rendemen tidak kurang dari 10% (Wardaningrum, 2019). Faktor yang mempengaruhi hasil ekstraksi antara lain varietas, tempat, suhu, jenis pelarut, metode ekstraksi dan ukuran partikel (Chairunnisa et al, 2019).…”