Performance evaluation of sigle row manual cotton planter

Abstract

: A proper placement of seed in field is most important operation in order to obtain optimum yield of crop. Day by day the land fragmentation was increased and which resulted near about 65 pre cent of the land holders are small and marginal land holding capacity in the region. Considering the limitations due to costly seed, traditional method of manual dibbling, labour shortage and small marginal land holding pattern there is need of small manual planter for small and marginal land holders. In view of the above, the manually operated seed planter was tested at Deptt. of Farm Power and Machinery, Dr. Panjabrao Deshmukh Krishi Vidyapeeth, Akola. A single row cotton planter was evaluated for performance by conducting laboratory and field tests. In laboratory test calibration of planter for seed rate, uniformity of seed planting and percentage of seed damage was determined at three cell plate, two gear ratio and level of seed in hopper. Based on the laboratory test cell plate, gear ratio and level of seed in hopper were selected for field test. The three trials of planter were taken for planting Bt-cotton crop. The field tests comprised of determination of effective field capacity, average depth of placement of seeds in the furrows and mean spacing of seeds within each row. The rate of work was observed to be in the range of 0.18 to 0.21 ha/h at forward speed of 2.24 to 2.5 km/h in well prepared seed bed along with the opened furrows. The average depth of planting was observed in the range of 4.5 cm to 5cm. The field efficiency of the planter was observed in the range of 88.88 to 91.1 per cent.

Design and Development of a Two-row Power Operated Maize Dibbler

“…The performance of seed metering plate was uniform throughout the operation when the seed hopper was maintained with three-fourth of its capacity [12]. A separate trapezoidal shaped seed hopper, made up of ABS plastic was provided in each dibbler.…”

Efecto de tres implementos de labranza sobre propiedades físicas de un suelo andisol en Tierra Blanca, Cartago

“…El funcionamiento del rotador se produce cuando se acopla a la toma de fuerza del tractor y se genera movimiento en el rotor central. Una serie de cuchillas en forma de 'L', adheridas al rotor central horizontal, y ubicadas en dirección vertical con respecto al suelo, se mueven a medida que el rotor gira (Mandal et al 2013, Behera et al 2021, Kankal et al 2016. Las cuchillas giran a una velocidad mayor a la del desplazamiento del implemento.…”