Performance of Cu<sub>2</sub>O/ZnO Solar Cell Prepared By Two-Step Electrodeposition

Katayama, Jun­ichi; Ito, Kazuki; Matsuoka, Makoto; Tamaki, Jun

doi:10.1023/b:jach.0000031166.73660.c1

Cited by 167 publications

(125 citation statements)

References 11 publications

Supporting

Mentioning

111

Contrasting

Unclassified

Order By: Relevance

“…[ 12 ] For electrodeposited bilayer cells, open-circuit voltages ranging from 0.19 to 0.59 V have been reported. [13][14][15] These results suggest that while the V OC may be sensitive to the particular electrodeposition conditions used, values approaching the expected limit are possible.…”

Section: Doi: 101002/adma201001455mentioning

confidence: 84%

Strong Efficiency Improvements in Ultra‐low‐Cost Inorganic Nanowire Solar Cells

et al. 2010

View full text Add to dashboard Cite

Section: Doi: 101002/adma201001455mentioning

confidence: 84%

Strong Efficiency Improvements in Ultra‐low‐Cost Inorganic Nanowire Solar Cells

et al. 2010

View full text Add to dashboard Cite

“…Other examples of mixed (or layered) oxide films involve p-Cu 2 O as one component [324][325][326][327]. Thus p-Cu 2 O was photochemically deposited on a chemically prepared n-ZnO/ quartz substrate [324].…”

Section: Electrodeposition Of Oxide Semiconductorsmentioning

confidence: 99%

Electrodeposition of Semiconductors

Schlesinger

Rajeshwar

2010

Modern Electroplating

View full text Add to dashboard Cite

“…P-type absorbing materials, which have a high production cost, are much-needed in the technology; thus the manufacturing of them, where there is a shortcoming, has a particular significance. The most common example of them is Cu 2 O thin films [6][7][8][9][10] . This mineral, which is widely present in the nature, is a quite stable compound.…”

Section: Introductionmentioning

confidence: 99%

Optical and Structural Properties of Natural MnSeO4 Mineral Thin Film

Kariper

2017

Mat. Res.

View full text Add to dashboard Cite

Manganese selenite (MnSeO 4 ) crystalline thin film has been produced with chemical bath deposition on substrates (commercial glass). Properties of the thin film, such as transmittance, absorption, and optical band gap and refraction index have been investigated via UV/VIS Spectrum. The structural properties of orthorhombic form have been observed in XRD. The structural and optical properties of MnSeO 4 thin films, deposited at different pH levels were analyzed. Some properties of the films have been changed with the change of pH level, which has been deeply investigated. The grain size of MnSeO 4 thin film has reached its highest value at pH 9. The refraction index and extinction coefficient of MnSeO 4 thin films were measured to be 1.53, 2.86, 2.07, 1.53 (refraction index) and 0.005, 0.029, 0.014, 0.005 (extinction coefficient) for grain sizes 21, 13, 26, and 5 nm respectively. The band gaps (Eg) of the films were measured to be 2.06, 2.57, 2.04, and 2.76 eV for the grain sizes mentioned above. The value of dielectric constant at pH 10 was calculated as 1.575.

show abstract

Performance of Cu₂O/ZnO Solar Cell Prepared By Two-Step Electrodeposition

Cited by 167 publications

References 11 publications

Strong Efficiency Improvements in Ultra‐low‐Cost Inorganic Nanowire Solar Cells

Strong Efficiency Improvements in Ultra‐low‐Cost Inorganic Nanowire Solar Cells

Electrodeposition of Semiconductors

Optical and Structural Properties of Natural MnSeO4 Mineral Thin Film

Contact Info

Product

Resources

About

Performance of Cu2O/ZnO Solar Cell Prepared By Two-Step Electrodeposition

Cited by 167 publications

References 11 publications

Strong Efficiency Improvements in Ultra‐low‐Cost Inorganic Nanowire Solar Cells

Strong Efficiency Improvements in Ultra‐low‐Cost Inorganic Nanowire Solar Cells

Electrodeposition of Semiconductors

Optical and Structural Properties of Natural MnSeO4 Mineral Thin Film

Contact Info

Product

Resources

About

Performance of Cu₂O/ZnO Solar Cell Prepared By Two-Step Electrodeposition