2012
DOI: 10.3390/ma5010157
|View full text |Cite
|
Sign up to set email alerts
|

Preparation and Thermal Characterization of Annealed Gold Coated Porous Silicon

Abstract: Porous silicon (PSi) layers were formed on a p-type Si wafer. Six samples were anodised electrically with a 30 mA/cm2 fixed current density for different etching times. The samples were coated with a 50–60 nm gold layer and annealed at different temperatures under Ar flow. The morphology of the layers, before and after annealing, formed by this method was investigated by scanning electron microscopy (SEM). Photoacoustic spectroscopy (PAS) measurements were carried out to measure the thermal diffusivity (TD) of… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
2

Citation Types

1
4
0

Year Published

2013
2013
2018
2018

Publication Types

Select...
7
3

Relationship

1
9

Authors

Journals

citations
Cited by 21 publications
(5 citation statements)
references
References 30 publications
1
4
0
Order By: Relevance
“…2 (f), the percentage of porosity shows a progressive increment up to approximately 35% and resulted to the decreased of thermal diffusivity from 4.58 x 10 -6 m 2 s -1 to 2.59 x 10 -6 m 2 s -1 . This behavior is in line with previous study [7]. The decreased in the thermal diffusivity with increased porosity is a consequence of the decrease in the mean free path, due to the phonon confinement in the crystallite [8,9].…”
Section: Resultssupporting
confidence: 93%
“…2 (f), the percentage of porosity shows a progressive increment up to approximately 35% and resulted to the decreased of thermal diffusivity from 4.58 x 10 -6 m 2 s -1 to 2.59 x 10 -6 m 2 s -1 . This behavior is in line with previous study [7]. The decreased in the thermal diffusivity with increased porosity is a consequence of the decrease in the mean free path, due to the phonon confinement in the crystallite [8,9].…”
Section: Resultssupporting
confidence: 93%
“…9 However, there are few works focusing on the applications of PS in alkali solution resulting from the corrosion and dissolution of PS in alkali solution. [10][11][12][13][14] Up to the present, there are no relevant research on PS corrosion and dissolution in alkali solution. As a result, in order to extend the study on the PS corrosion in alkali solution, several PS samples were fabricated by electrochemical anodisation, and a detailed study into the effect of organic solvent, temperature and concentration on the corrosion rate for PS in KOH and NaOH aqueous solution was investigated by weight loss measurements.…”
Section: Introductionmentioning
confidence: 99%
“…When the frequency was increased, the sample became thermally thick, and the thermal waves penetrated into the sample; the detector then produced a PE signal, and this PE signal decreased exponentially with increasing frequency modulation. At high frequencies in the range of 50 to 200 Hz, the anomalous signal was very small and largely independent of the frequency [ 30 ]. The PE signals were therefore fitted only in the thermally thick area, and the curves were linear in the useful frequency range of 5 to 30 Hz, as shown in Figure 7 B.…”
Section: Resultsmentioning
confidence: 99%