Protective Relays

Warrington, A. R. van C.

doi:10.1007/978-1-4684-6459-7

Cited by 59 publications

(6 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Setelan waktu kerja relai arus labih standart inverse didapat dengan menggunakan rumus kurva waktu dan arus [5], [6] Berdasarkan gambar 4.8, perbedaan seting relai OCR sisi incoming antara data dan hasil perhitungan sama, tms berdasarkan data = 0,201 dan waktu kerja = 0,7 detik. Berdasarkan analisa tms = 0,195 dan waktu kerja = 0,7 detik.…”

Section: Penyetelan Waktu Kerja Relaiunclassified

Koordinasi Sistem Proteksi Arus Lebih Pada Penyulang Distribusi 20 kV GI Pauh Limo

Erliwati¹,

Syafii²,

Nurdin³

2015

JNTE

View full text Add to dashboard Cite

Pada penyulang 20 kV biasanya pemadaman disebabkan oleh gangguan hubung singkat. Jika penyetelan over current relay (OCR) di sisi incoming atau di outgoing kurang baik, dapat menyebabkan pemadaman total (black out). Salah satu upaya yang dilakukan adalah dengan mengevaluasi setting relai proteksi pada penyulang distribusi 20 kV gardu induk Pauh Limo, sehingga saling terkoordinasi dengan baik dan diharapkan jika terjadi gangguan pada salah satu penyulang 20 kV maka tidak akan membawa black out pada penyulang yang lain. Berdasarkan analisa arus hubung singkat disetiap penyulang, dimana arus gangguan hubung singkat 3 fasa terbesar yaitu pada penyulang Koto Tingga, dengan lokasi gangguan 1 %, yaitu sebesar 7326,99 Ampere. Hal ini dikarenakan saluran Koto Tingga terpendek dibandingkan dengan penyulang lain, yaitu = 9 km dan arus beban = 230 Amper. Waktu kerja relai pada penyulang (detik) : Kuranji = 0,

show abstract

Section: Penyetelan Waktu Kerja Relaiunclassified

Koordinasi Sistem Proteksi Arus Lebih Pada Penyulang Distribusi 20 kV GI Pauh Limo

Erliwati¹,

Syafii²,

Nurdin³

2015

JNTE

View full text Add to dashboard Cite

show abstract

“…The largest errors are usually caused by the fault resistance, however. In the case of power arc, this can be calculated as follows [4]:…”

Section: Performance Of the Fault Location Systemmentioning

confidence: 99%

A new technique for short circuit fault location in distribution networks

Vahamaki¹,

Hänninen²,

Lehtonen³

2005

18th International Conference and Exhibition on Electricity Distribution (CIRED 2005)

View full text Add to dashboard Cite

A novel technique for short circuit fault location in distribution networks is presented. The technique computes the fault distance as reactance, based on the measurement of busbar voltages and feeding primary substation currents. The key factor is the compensation of the load currents superposed on the fault current. This leads to the accuracy, which is even better than with the previous methods, with the other difference being, that only one or two measuring device is needed, depending on the number of primary transformers at the substation.

show abstract

“…In this works of art streamlining methods are executed for most appropriate co-appointment of directional overcurrent transfers. This theory talks about the use of Particle Swarm Optimization (PSO) calculation for most worthwhile coordination of DOCR transfers in a 8 bus power [2] machine system. Blend of essential and reinforcement hand-off is chosen by means of the utilization of far and close stop vector of shape, to maintain a strategic distance from miscoordination of transfers.…”

Section: Introductionmentioning

confidence: 99%

PSO based Directional Relay Parameter Tuning for Smart Grid Systems Protection

2020

IJETER

View full text Add to dashboard Cite

Power system grid are upgraded by enhancement of directional over-current-relays (DOCRs) setting is a basic issue in electrical designing. The smart grid advancement model of the issue end up being non-direct and rather controlled wherein setting especially time dial setting (TDS) and plugging setting (PS) of each hand-off are set over a choice factors; the total of the working on all the essential transfers, which are anticipated to work that enable to clear the issue in their relating zones, considered as main objective. In the predominant analyze, demonstrate thought about especially IEEE eight-bus power syatem. To comprehend the problem, we have connected PSO based smart mechanism to upgrade the normal power system grid to smart grid. The outcome are a contrasted and the traditional arrangement of intelligent guideline followed by relays; the numerical outcome demonstrate that the changed calculation outflank or perform at standard with different calculations. In light of the intelligent coordination result acquired on the investigations, the proposed optimized enhancement set of principle can be utilized to compute the setting of the directional overcurrent transfer in a distribution community with allotted generation demand of smart grid. The proposed set of rule has shown to have the potential to keep selectivity among the relay being coordinated and limit the running time of the primary relay for close-in 3-phase faults.

show abstract

Protective Relays

Cited by 59 publications

References 0 publications

Koordinasi Sistem Proteksi Arus Lebih Pada Penyulang Distribusi 20 kV GI Pauh Limo

Koordinasi Sistem Proteksi Arus Lebih Pada Penyulang Distribusi 20 kV GI Pauh Limo

A new technique for short circuit fault location in distribution networks

PSO based Directional Relay Parameter Tuning for Smart Grid Systems Protection

Contact Info

Product

Resources

About