1956
DOI: 10.1021/ja01594a029
|View full text |Cite
|
Sign up to set email alerts
|

Relative Electron Densities in Substituted Benzenes1

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1

Citation Types

2
38
0

Year Published

1960
1960
2007
2007

Publication Types

Select...
7
2

Relationship

0
9

Authors

Journals

citations
Cited by 133 publications
(40 citation statements)
references
References 0 publications
2
38
0
Order By: Relevance
“…The ultraviolet absorption maxima of many of these compounds a r e listed in Table I Scheme I) will scarcely alter the frequencies of absorption of the protons on the most distant ring d. On the other hand, on the bases of the known relative chemical shifts (as compared to benzene as a standard) for the benzenoid hydrogens in N-methylaniline (shift to higher field: 0.80 for o-H, 0.30 for m-H, and 0.57 for p-H, in p.p.m.) and in benzylamine (shift to higher field: 0.03 for each H) (14) were nearly identical as would be expected if absorption there resulted from some of the protons in ring d . Correspondingly, and consistent with expectations, absorptions in the range from 6.5 to ca.…”
supporting
confidence: 63%
“…The ultraviolet absorption maxima of many of these compounds a r e listed in Table I Scheme I) will scarcely alter the frequencies of absorption of the protons on the most distant ring d. On the other hand, on the bases of the known relative chemical shifts (as compared to benzene as a standard) for the benzenoid hydrogens in N-methylaniline (shift to higher field: 0.80 for o-H, 0.30 for m-H, and 0.57 for p-H, in p.p.m.) and in benzylamine (shift to higher field: 0.03 for each H) (14) were nearly identical as would be expected if absorption there resulted from some of the protons in ring d . Correspondingly, and consistent with expectations, absorptions in the range from 6.5 to ca.…”
supporting
confidence: 63%
“…In the light of this conclusion we can discuss the observations on monosubstituted benzenes made by Corio and Dailey [8]. They found that the aromatic part of the spectrum of toluene consists of one single line.…”
Section: Discussionmentioning
confidence: 74%
“…The impurity data given in Table I indicate that the high-purity silver used was actually an alloy with a melting range between the solidus and liquidus of a few tenths of a degree or less. 7 The melting range was determined primarily by the presence of oxygen in concentrations which may actually have been lower than the indicated 1-3 ppm because of a possible reducing effect of the graphite at 960°C. The decrease in Bragg intensity, beginning about 0.08C below the temperature at which melting was first observed, was therefore most likely due to the gradual formation of a two-phase solid-liquid structure starting at the solidus temperature and extending over a temperature range of a tenth of a degree or so.…”
Section: Discussionmentioning
confidence: 99%
“…in a second horizontal groove in the graphite core located just 3 mm above the top surface of the bar specimen ( (1) Gas-tight InconeI furnace tube, (2) graphite core, (3) x-ray grain in bar specimen, (4) Pt vs Pt-lO% Rh thermocouple, (5) fused quartz thermocouple tube, (6) thermocouple junction, (7) x-ray port heater winding, (8) Mylar window, (9) furnace casing, (10) powdered insulation, (11) incident and diffracted x-rays, (12) aperture in graphite core for x-rays, (13) longitudinal furnace heater, (14) water cooling tubes. men, because changes in the temperature gradients in the entire x-ray specimen region of the furnace were exceedingly small (see below).…”
Section: Specimen Temperaturementioning
confidence: 99%