Reliability Testing and Stress Measurement of QFN Packages Encapsulated by an Open-Ended Microwave Curing System

Abstract

Abstract-In this paper, the influence of microwave curing on the reliability of a representative electronic package is examined by reliability testing and measurement of residual stresses. A LM358 voltage regulator die was mounted to an open Quad Flat No-leads package (QFN) for reliability testing. For the stress measurement, a specifically designed stress measurement die was mounted to the QFN package. The chips were encapsulated with_Hysol EO1080 thermosetting polymer material. Curing was performed using an open-ended microwave oven system equipped with in situ temperature control. Three different temperature profiles for microwave curing were selected according to the requested degree of cure and chemical composition of the cured material. A convection cure profile was selected for the control group samples. Thermal cycling and HAST tests were performed on a total number of 80 chips. 95 QFN packages with stress measurement chips were also manufactured. Increased lifetime expectancy of the microwave cured packaged chips was experimentally demonstrated and measured between 62% to 149% increased lifetime expectancy after Temperature Cycling Test (TCT), and between 63% and 331% after highly Accelerated Ageing Test (HAST) and TCT compared to conventionally cured packages. Analysis of specifically designed stress test chips showed significantly lower residual stresses ranging from 26 MPa to 58.3 MPa within the microwave cured packages compared to conventionally cured packaged chips which displayed residual stresses ranging from 54 MPa to 80.5 MPa. This article therefore provides additional confidence in the industrial relevance of the microwave curing system and its advantages compared to traditional convection oven systems.

Comparative Reliability of Inkjet-Printed Electronics Packaging

“…The polymer substrates used in the fabrication process are effectively transparent to the microwave radiation, so they are not directly affected by the process. While the adoption of microwave processing techniques for the fabrication of microelectronics packaging is relatively rare, studies have demonstrated that the technique can be highly advantageous [24][25][26][27].…”

A Ku-Band Miniaturized System-in-Package Using HTCC for Radar Transceiver Module Application

“…Therefore, for the QFN, the conductive path between the internal pins and the bottom pads is short, and the selfinductance coefficient and the wiring resistance in the package are low. These characteristics give the QFN package outstanding electrical performance [18][19][20][21][22][23]. In addition, it also provides excellent thermal performance through exposed lead frame pads, which are direct thermal channels for dissipating heat within the package.…”

A Dual-Band Non-destructive Dielectric Measurement Sensor Based on Complementary Split-Ring Resonator

“…For instance, in the design of microwave and millimeter wave planar circuits, the dielectric constant of the substrate material has to be known as a priori. With the fast evolving of electronic technologies, materials are involved in many areas such as manufacturing processing, antenna design, and aerospace technology [2][3][4][5]. Therefore, precision measurement of the dielectric constant is becoming more and more critical.…”