Research on Load Disturbance Based Variable Speed PID Control and a Novel Denoising Method Based Effect Evaluation of HST for Agricultural Machinery

Abstract

This paper aims to realize and improve the constant speed control performance of tractors with HST (Hydrostatic Transmission) variable speed units. To achieve this, based on the HST test bench of the tractor, we perform a verification test of the adjustable speed characteristics, a denoising filter test of the response signal, a test on the influence of the load disturbance on the adjustable speed characteristics and a PID-based constant speed performance detection test. The results of the verification test of the adjustable speed characteristics show that the theoretical value and actual value of the adjustable speed transmission characteristics of the HST used are essentially consistent with each other. The results of the test of the load disturbance’s influence on the adjustable speed characteristics show that the increase in load torque inhibits the HST output response. Therefore, the paper proposes and designs a PID-based closed-loop constant speed control system. The paper uses a step response test and a load disturbance test to research the control result of the constant speed system. Collecting and analyzing all test results, we find that the constant speed control based on PID has a very good result. The average error between the average HST output speed and the target speed set was 0.37%, and the average standard deviation of output speed was 1.18 rpm. In addition, the paper proposes a denoising method combing the empirical mode decomposition method and the Gaussian distribution determination. The method shows that the first two orders of the components of the HST response signal should be removed as noise. The paper uses the denoised signal and the partial least squares method to analyze the influencing factors of the constant speed control result. The analysis results show that the rate of change of load torque has the biggest influence on the stability of HST output speed, followed by the target value.

Research on Curving Acc System for Electric Vehicle Driven by In‐wheel Motors Based on Fmpc And Smc

“…Cruise mode is a basic mode of the ACC system, which receives the cruise speed preset by the driver, so that the vehicle by accelerating or decelerating to reach the cruise speed and keep driving at a constant speed. [ 19 ] The implementation of the control algorithm of the cruise control controller is relatively easy, so this paper adopts the PID control algorithm to design the cruise mode controller.…”

Review on the Selection of Health Indicator for Lithium Ion Batteries

“…Finally, combined with genetic algorithm and support vector machine, the battery RUL is predicted. In addition to the above methods for smoothing the initial data, methods such as moving average and Gaussian filtering are often used [54,55].…”

“…When the selected variable is a continuous function and obeys a normal distribution, using the Pearson correlation coefficient has a better effect. If any of the above conditions are not met, the Spearman correlation coefficient is more efficient [54,79]. In addition, some researchers employ Box-Cox variation to improve the correlation between feature quantities and estimators [80,81].…”

Research on trajectory tracking and body attitude control of autonomous ground vehicle based on differential steering

“…With the increasingly severe air pollution and energy crisis, electric vehicles (EVs) have attracted extensive attention from research institutions in various countries because of the characteristics of energy conservation and environmental protection [1], such as the energy management strategy [2], the fuel cell [3,4], the battery SOC estimation [5][6][7], the different driving modes [8][9][10][11]. Relative speaking, due to the unstable operation of the engines, the strength requirements of parts are also higher [12,13].…”