Review and critical analysis of the research papers published till date on maximum power point tracking in wind energy conversion system

Kazmi, Syed Muhammad Raza; Goto, Hiroki; Guo, Hongyan; Ichinokura, O.

doi:10.1109/ecce.2010.5617747

Cited by 117 publications

(63 citation statements)

References 38 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…For aggregated residential load, combining a group of houses, a considerable change in demand can occur in the range of minutes. On the other hand, wind speed may vary very dramatically in a matter of few seconds [147]. Therefore, the bandwidth of the dc-link current controller should be higher than the frequency of wind speed variation.…”

Section: Parameters Design Of Dc-link Current Pi Controllermentioning

confidence: 99%

“…Different techniques for maximum power point tracking, reported in the literature, have been reviewed in [148]. technique can provide the fastest control action because it depends on direct measurement of the wind speed and sets the control reference instantaneously, resulting in more energy production [147], [149]. In this chapter, therefore, the TSR technique is implemented to achieve MPPT.…”

Section: Mppt Control Schemementioning

confidence: 99%

See 1 more Smart Citation

A small-scale standalone wind energy conversion system featuring SCIG, CSI and a novel storage integration scheme

Alnasir

Kazerani

2016

Renewable Energy

View full text Add to dashboard Cite

Small-scale standalone wind turbines provide a very attractive renewable energy source for off-grid remote communities. Taking advantage of variable-speed turbine technology, which requires a partial-or full-scale power converter, and through integrating an energy storage system, smooth and fast power flow control, maximum power point tracking, and a highquality power is ensured.Due to high reliability and efficiency, permanent magnet synchronous generator seems to be the dominating generator type in gearless wind turbines, employed for off-grid applications.However, wind turbines using geared squirrel-cage induction generator (SCIG) are still widely accepted due to their robustness, simplicity, light weight and low cost. Permanent magnet induction generator, a relatively new induction-based machine, has recently been recognized in the wind energy market as an alternative for permanent magnet synchronous generator. A thorough comparative study, among these three generator types, is conducted in this research in order to enable selection of the most appropriate generator for off-grid wind energy conversion system (WECS), subject to a set of given conditions. The system based on geared SCIG has been shown to be the most appropriate scheme for a small-scale standalone WECS, supplying a remote area.Different topologies of power electronic converters, employed in WECSs, are overviewed.Among the converters considered, current source converter is identified to have a great potential for off-grid wind turbines.Three current-source inverter-based topologies, validated in the literature for on-grid WECS, are compared for off-grid WECS application. Feasibility study and performance evaluation are conducted through analysis and simulation. Among all, the topology composed of three-phase diode bridge rectifier, DC/DC buck converter, and pulse-width-modulated current-source inverter (PWM-CSI) is identified as a simple and low-cost configuration, offering satisfactory performance for a low-power off-grid WECS.A small-scale standalone wind energy conversion system featuring SCIG, CSI and a novel energy storage integration scheme is proposed and a systematic approach for the dc-link inductor design is presented. iv In developing the overall dynamic model of the proposed wind turbine system, detailed models of the system components are derived. A reduced-order generic load model, that is suitable for both balanced and unbalanced load conditions, is developed and combined with the system components in order to enable steady-state and transient simulations of the overall system. A linear small-signal model of the system is developed around three operating points to investigate stability, controllability, and observability of the system. The eigenvalue analysis of the small-signal model shows that the open-loop system is locally stable around operating points 1 and 3, but not 2. Gramian matrices of the linearized system show that the system is completely controllable at the three operating points and completely observable at...

show abstract

Section: Parameters Design Of Dc-link Current Pi Controllermentioning

confidence: 99%

Section: Mppt Control Schemementioning

confidence: 99%

A small-scale standalone wind energy conversion system featuring SCIG, CSI and a novel storage integration scheme

Alnasir

Kazerani

2016

Renewable Energy

View full text Add to dashboard Cite

show abstract

“…The optimal power P opt is determined using (21). In terms of implementation, Raza and other researchers [40], [41] show that the PSF and OT control methods have the same performance and complexity.…”

Section: Optimal Torque Controlmentioning

confidence: 99%

“…The method of OT is fast and simple. However, its efficiency is lower compared with the TSR control because it does not measure the wind speed directly, which means that the wind changes are not reflected instantaneously [40]. Figure 13 shows the block diagram of a wind energy system with Power Signal Feedback (PSF) controller for maximum power extraction.…”

Section: Optimal Torque Controlmentioning

confidence: 99%

Modeling and Control of Micro-grid Powered by Solar and Wind Energies

Zenned¹,

Aridhi²,

Mami³

2017

IJPEDS

View full text Add to dashboard Cite

The number of installations of Micro-Grid or intelligent micro power networks will increase to quadruple by 2020.The purpose is to reduce the cost and the consumption of electricity in transmission and distribution networks, using a hybrid system powered by solar and wind sources, as well as integrating storage devices. This paper reviews and discusses the MicroGrid Model. It describes various Micro-Grid components and different configurations. It also presents the model of two generation units (Photovoltaic and Wind Turbine). Then, a comparative study of different battery types used for large-scale electricity storage is carried out, followed by a review of control strategies.

show abstract

“…A good analysis of MPPT methods is provided in [16,[37][38][39]. The most widely applied algorithm is the "perturb and observe" (P&O) method.…”

Section: Mppt Controlmentioning

confidence: 99%

A New Application of the Multi-Resonant Zero-Current Switching Buck Converter: Analysis and Simulation in a PMSG Based WECS

2015

View full text Add to dashboard Cite

Abstract:A new application of the three-phase buck-resonant converter is presented in this paper. It is shown that the analyzed converter is suitable to operate as the rectifier stage in low power wind energy conversion systems (WECS) based on permanent magnet synchronous generators (PMSG) with variable wind speed. As main features, it presents a single controlled switch, simple implementation and control, and operates with a high power factor and low harmonic distortion over all wind speed ranges. The converter topology, its design equations and its operation are presented, as well as the simulation results of the PMSG based conversion system. From the analysis carried out in the paper it is concluded that the converter is indicated to be employed in distributed generation and hybrid systems where wind generation is associated with other sources.

show abstract

Review and critical analysis of the research papers published till date on maximum power point tracking in wind energy conversion system

Cited by 117 publications

References 38 publications

A small-scale standalone wind energy conversion system featuring SCIG, CSI and a novel storage integration scheme

A small-scale standalone wind energy conversion system featuring SCIG, CSI and a novel storage integration scheme

Modeling and Control of Micro-grid Powered by Solar and Wind Energies

A New Application of the Multi-Resonant Zero-Current Switching Buck Converter: Analysis and Simulation in a PMSG Based WECS

Contact Info

Product

Resources

About