State-of-the-Art Method Denoising Electrocardiogram Signal: A Review

Maghfiroh, Anita Miftahul; Musvika, Syevana Dita; Wakidi, Levana Forra; Titisari, Dyah; Setiawan, Singgih Yudha; Amrinsani, Farid; Azhari, Dandi Hafidh

doi:10.1007/978-981-19-1804-9_24

Cited by 2 publications

(1 citation statement)

References 35 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This method is preferred to conventional stethoscopes, but the noise is still too large so that a pre amplifier and filter are needed to filter out unwanted frequencies [19]. In this case, in order to eliminate noise interference, there are several filters that are recommitted by several researchers including IIR filters, Chebichev, Wavelet, and so on [20] [21].…”

Section: Introductionmentioning

confidence: 99%

Electronic Stethoscope Design with IoT (Internet of Things)-based Disease Symptom Detection

Hamzah

Setioningsih

Sumber

et al. 2022

Indones.J.electronic.electromed.med.inf

View full text Add to dashboard Cite

Auscultation is a technique or method most often used by medical personnel in the initial examination of patients. One way is to use a stethoscope. However, this method has its drawbacks because the diagnosis is carried out subjectively and cannot be relied on with the accuracy to diagnose the symptoms of heart defects. Thus, the purpose of this study is to create an IoT system for electronic stethoscopes with BPM value output and make analog filters to eliminate noise interference which was a major obstacle in previous studies. The contribution to this study is to make it easier for medical users to monitor vital conditions, namely BPM remotely and produce BPM values in real-time. The method used in this study was to use a mic condensor placed on the patient's chest to detect pressure changes that occurred. This change in pressure causes a change in the voltage output value on the condensor mic. Output dari mic condenser masuk dan diproses di rangkaian PSA. Output sinyal dari PSA masuk ke mikrokontroler yang telah diprogram. Hasil yang dipeoleh dari pengukuran mengasilkan nilai error pengukuran nilai BPM dari 5 responden dan diperoleh nilai error yang dihasilkan dari responden 1 diperoleh error sebesar 0.33 BPM, responden 2 diperoleh nilai error sebesar 0,67 BPM, responden 3 memiliki nilai error sebesar 0,5 BPM, responden 4 nilai error sebesar 0,67 dan responden 5 mempunyai nilai error sebesar 0,67 BPM. The results of the statistical test were also obtained P-Value>0.05 which explained that the resulting value did not have a significant difference and could be used for medical purposes. This research can help make it easier for doctors to analyze and diagnose symptoms of heart defects because this system is equipped with the detection of disease symptoms.

show abstract

Section: Introductionmentioning

confidence: 99%