Surface modification of plasma spraying A_l2O₃–13 wt% TiO₂ coating by laser remelting technique

Abstract

An Al2O3-13 wt.% TiO2 composite ceramic coating was prepared on the TiAl alloy surface by plasma spraying and laser remelting combined technique. The morphology, microstructure, and phase composition of the prepared coating were analyzed by scanning electron microscopy, energy disperse spectroscopy, and X-ray diffraction. The bonding strength, microhardness, wear resistance, erosion resistance, and thermal shock resistance of the coating were also tested. Results demonstrated that after processing by laser remelting, the particles on the ceramic coating surface were refined, lamellar structure disappeared, and density increased. A remelting layer basically without crack and other defects was gained. Due to laser remelting, the metastable-phase γ-Al2O3 was converted into stable-phase α-Al2O3. Influenced by the low thermal conductivity of ceramic materials, remelting of the whole ceramic layer is impossible to realize during laser remelting. The remelted ceramic coating formed the isometric crystal remelting zone with small grain size, sintering zone, and lamellar residual plasma spraying zone. The bonding strength and microhardness of the coating improved significantly after laser remelting, and the wear resistance, erosion resistance, and thermal shock resistance were significantly superior to those of the original plasma spraying layer. Laser remelting specimens still represented typical brittle erosion characteristics. Cracks initiated and expanded on near surface, finally leading to breakage of the remelting layer, mainly manifested by grain peeling. With respect to thermal shock failure mode, the corner peeling is the major failure mode of the ceramic coating after plasma spraying. Differently, corner peeling and considerable local peelings were found at the center of the ceramic coating after laser remelting. The influences of laser remelting on the thermal shock performances of the coating are mainly manifested as the decreased initial failure resistance, decelerated crack expansion, and changes in failure modes of the coating.

Optimization of cold spray process parameters to maximize adhesion and deposition efficiency of Ni+Al2O3 coatings

“…For the adhesion strength of coatings: For the deposition efficiency (DE): The equations ( 6) and (7) in terms of actual factors can be used to make predictions about the responses for given levels of each factor. Here, the levels should be specified in the original units for each factor.…”

“…Today, it is difficult to name industries where gas-flame spraying [5], electric arc metallization [6], plasma [7], and detonation [8] coating spraying could not be successfully used. One of the traditional applications of thermal spraying is aerospace and aviation, in which heat-protective, heat-, corrosion-, and wear-resistant coatings are widely used, with hundreds of different types in the nomenclature [9].…”

Wear characteristics of flat die in flat die pellet mills based on Glycyrrhiza uralensis

“…K2 also contains Ti, which can form TiO 2 on the surface in case of wear. It has the effect of friction reduction and wear resistance [21][22][23][24][25] to prevent further damage to the friction layer, which makes K2 have good wear resistance.…”

Preparation and frictional characteristics of solid lubrication coating on CFRP surface

“…Thermal spraying preparation options include electroplating, laser cladding, flame spraying, etc. [22–25], cold spraying method does not need to melt the coating material at high temperature, and directly uses high-speed air to hit the material to be sprayed on the substrate to obtain a uniform and dense coating [26–29]. The bonding method is a suitable approach for creating solid lubricating coatings on CFRP-based substrates.…”