Synthesis and characterization of swelling properties superabsorbent Hydrogel Carboxymethylcellulose-g-Poly (Acrylic Acid)/Natrium Alginate cross-linked by gamma-ray irradiation technique

Putro, Permono Adi; Sulaeman, Ahmad Sofyan; Erizal,

doi:10.1088/1742-6596/1171/1/012011

Cited by 3 publications

(2 citation statements)

References 50 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The Author(s). Published by CBIORE low cost, non-toxic to the environment, and exhibits good film-forming ability (Mazuki et al 2020;Megha et al 2018;Putro et al 2019). It has been studied in a lots of works which developed CMC in the electrolytes system with promising conduction properties (Mazuki et al 2020;Mazuki et al 2019).…”

Section: Research Articlementioning

confidence: 99%

Enhancing Ionic Conductivity of Carboxymethyl Cellulose-Lithium Perchlorate with Crosslinked Citric Acid as Solid Polymer Electrolytes for Lithium Polymer Batteries

Maddu

Sulaeman

Wahyudi

et al. 2022

Int. J. Renew. Energy Dev.

View full text Add to dashboard Cite

Lithium batteries development are triggered so many efforts in producing electronic devices due to its excellent performance as energy storage systems. One of the appealing points solid polymer electrolytes for developing solid-state lithium batteries. In this study, Solid polymer electrolytes with crosslinked treatment (SPE-C) were prepared from carboxymethyl cellulose-lithium perchlorate (CMC-LiClO4) and citric acid (CA) as a crosslinker via solution casting method. All SPE-C membranes were assembled into lithium battery coin cells. Degree of crosslinked and degradation were measured to observe crosslink formation in SPE-C membranes and confirmed by fourier transform infrared (FTIR), whereas SPE-C in coin cells were characterized by electrochemical impedance spectroscopy (EIS) and linear sweep voltammograms (LSV). The results showed that crosslinked process is successfully obtained with C=O from ester linkage of CA vibration within COO- of CMC for the crosslinking bond formation. The crosslink effect also contributed on enhancing ionic conductivities of SPE-C in coin cells from EIS results. The highest ionic conductivity was obtained in SPE-C2 (1.24×10-7 S/cm) and electrochemically stable in 2.15 V based on LSV measurement. SPE-C2 has good dielectric behavior than the others due to the high ions mobilities for migration process from ion clusters formation, thus it would be useful for further study in obtaining the powerful solid-state lithium polymer batteries.

show abstract

Section: Research Articlementioning

confidence: 99%

Enhancing Ionic Conductivity of Carboxymethyl Cellulose-Lithium Perchlorate with Crosslinked Citric Acid as Solid Polymer Electrolytes for Lithium Polymer Batteries

Maddu

Sulaeman

Wahyudi

et al. 2022

Int. J. Renew. Energy Dev.

View full text Add to dashboard Cite

show abstract

“…2,10 One of the synthetic polymers often used for hydrogel synthesis is poly(acrylic acid) (PAA). [11][12][13][14][15][16][17][18] PAA is made from acrylic acid monomer (Figure 1.) and cross-linked to produce hydrogels.…”

Section: Introductionmentioning

confidence: 99%

Thermal studies of hydrogels based on poly(acrylic acid) and its copolymers by differential scanning calorimetry: A systematic literature review

Sulaeman

Putro

Nikmatin

2022

Polymers and Polymer Composites

View full text Add to dashboard Cite

This systematic literature review aims to study the thermal properties (TP) of poly(acrylic acid)-based hydrogels (PAA) by differential scanning calorimetry. The data sources were obtained from Google Scholar via Publish or Perish software from 2018 to 2020. The synthesis results show that most of the analysis of TP in PAA-based hydrogel consists of glass transition temperature ([Formula: see text]), melting temperature ([Formula: see text]), and enthalpy ([Formula: see text]). The subsequent thermal properties analysis is important for a new development and depth study in the future application.

show abstract

Spectroscopic Study on the Film of Polyvinyl Alcohol and Carboxymethyl Cellulose as Polymer Electrolyte Materials

Putro

Yudasari

Maddu

2020

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

Polymer electrolytes have emerged as a powerful platform in the progress of more efficient energy storage devices. In this study, polymer electrolyte materials (PEM) was successfully prepared using drop casting method. A spectroscopic study of the film were prepared by variying the ratio of the volume (PVA/CMC) at 100/0, 75/25, 50/50, 25/75 %. The functional groups were investigated using fourier transform infrared (FTIR) spectroscopy. The crystallinity degree obtained by X-ray diffraction (XRD). Their transparency degree were observed by UV-Vis spectroscopy. The ionic conductivity studies obtained by electrochemical impedance spectroscopy (EIS).

show abstract

Synthesis and characterization of swelling properties superabsorbent Hydrogel Carboxymethylcellulose-g-Poly (Acrylic Acid)/Natrium Alginate cross-linked by gamma-ray irradiation technique

Cited by 3 publications

References 50 publications

Enhancing Ionic Conductivity of Carboxymethyl Cellulose-Lithium Perchlorate with Crosslinked Citric Acid as Solid Polymer Electrolytes for Lithium Polymer Batteries

Enhancing Ionic Conductivity of Carboxymethyl Cellulose-Lithium Perchlorate with Crosslinked Citric Acid as Solid Polymer Electrolytes for Lithium Polymer Batteries

Thermal studies of hydrogels based on poly(acrylic acid) and its copolymers by differential scanning calorimetry: A systematic literature review

Spectroscopic Study on the Film of Polyvinyl Alcohol and Carboxymethyl Cellulose as Polymer Electrolyte Materials

Contact Info

Product

Resources

About