The Effect of Reinforcement Preheating Temperatures on Tribological Behavior of Advanced Quranic Metal-Matrix Composites (QMMC)

Abstract

The growing applications of iron/copper bimetallic composites in various industries are increasing. The relationship between the properties of these materials and manufacturing parameters should be well understood. This paper represents an experimental study to evaluate the effect of reinforcement (steel rod) preheating temperature on the mechanical properties (bond strength, microhardness, and wear resistance) of copper matrix composites (QMMC). In preparing the QMMC samples, the melted copper was poured on a steel rod that had been preheated to various temperatures, namely, room temperature, 600 °C, 800 °C, and 1200 °C. Properties of the QMMC (interface microstructure, interfacial bonding strength, microhardness, and wear) were investigated. The experimental results revealed that the best bond between the copper matrix and steel rod formed only in the composites prepared by preheating the steel rods with temperatures lower than the recrystallization temperature of steel (723 °C). This is because the oxide layer and shrinkage voids (due to the difference in shrinkage between the two metals) at the interface hinder atom diffusion and bond formation at higher temperatures. The microhardness test showed that preheating steel rod to 600 °C gives the highest value among all the samples. Furthermore, the QMMC’s wear behavior confirmed that the optimization of preheating temperature is 600 °C.

Microstructure and Mechanical Properties of Hybrid AZ91 Magnesium Matrix Composite with Ti and SiC Particles

“…are also applied. The reinforcements are chiefly ceramic particles, short fibers or whiskers such as C graphite , SiC, TiC, Al 2 O 3 , TiN (or different carbides, oxides, nitrides) and fly ash microspheres, nanotubes, graphene or MAX phases [1][2][3][4][5][6][7][8][9][10][11][12][13][14][15][16][17][18][19]. It should also be noted that in the last decade, metal-metal composites were also fabricated.…”