The role of Stewartson and Ekman layers in turbulent rotating Rayleigh–Bénard convection

Abstract

When the classical Rayleigh-Bénard (RB) system is rotated about its vertical axis roughly three regimes can be identified. In regime I (weak rotation) the large scale circulation (LSC) is the dominant feature of the flow. In regime II (moderate rotation) the LSC is replaced by vertically aligned vortices. Regime III (strong rotation) is characterized by suppression of the vertical velocity fluctuations. Using results from experiments and direct numerical simulations of RB convection for a cell with a diameter-to-height aspect ratio equal to one at Ra ∼ 10 8 − 10 9 (P r = 4 − 6) and 0 1/Ro 25 we identified the characteristics of the azimuthal temperature profiles at the sidewall in the different regimes. In regime I the azimuthal wall temperature profile shows a cosine shape and a vertical temperature gradient due to plumes that travel with the LSC close to the sidewall. In regime II and III this cosine profile disappears, but the vertical wall temperature gradient is still observed. It turns out that the vertical wall temperature gradient in regimes II and III has a different origin than that observed in regime I. It is caused by boundary layer dynamics characteristic for rotating flows, which drives a secondary flow that transports hot fluid up the sidewall in the lower part of the container and cold fluid downwards along the sidewall in the top part. arXiv:1109.6867v1 [physics.flu-dyn]

Exploring the geostrophic regime of rapidly rotating convection with experiments

“…11 and 12. At small enough Ro, experiments and direct numerical simulations (DNSs) of the full Navier-Stokes equations (in the Boussinesq approximation) should give similar results as simulations of the asymptotically reduced equations. Up to now, most of the experiments [13][14][15][16][17][18][19][20][21][22][23] and DNSs 16,18,[24][25][26][27] did not reach deep into the rapidly rotating convection regime. The few experimental and numerical studies that entered decisively into this regime 9,[28][29][30] primarily use the overall heat transfer to characterize rapidly rotating Rayleigh-Bénard convection and identify transitions between flow regimes from changes in the heat-flux scaling.…”

Turbulent convection in liquid metal with and without rotation

“…Of recent interest in these studies have been transitions between rotationally dominated and nonrotating turbulent states (2-10) and the enhancement of heat transport by rotation (6,8,(11)(12)(13)(14)(15). Numerical simulations of planetary dynamo action by rotating convection also concentrate on fluids with unit order Pr (16).…”

Boundary layer structure in confined turbulent thermal convection

“…The extreme thinness of the boundary layers poses difficult challenges to the experimental techniques while numerical simulations need to use the largest computers now available to attack this parameter range. Another point deserving investigation is the structure of the boundary layers in the presence of background rotation that introduces the Rossby number as additional input and increases the complexity of the physics with the Ekman and Stewartson layers (Kunnen et al 2011). All these topics are being clarified thanks to the combination of theoretical models, laboratory experiments and numerical simulation all involved in the joint effort to unravel the complex dynamics of the turbulent Rayleigh-Bénard flow.…”