2020
DOI: 10.1007/s10765-019-2600-7
|View full text |Cite
|
Sign up to set email alerts
|

Thermophysical Properties Analysis of Poly (Ethylene Glycol) 600 + Methanol, Ethanol, 1-Propanol, and 2-Propanol Binary Liquid Mixtures

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1

Citation Types

2
8
0
1

Year Published

2020
2020
2024
2024

Publication Types

Select...
8
1

Relationship

0
9

Authors

Journals

citations
Cited by 23 publications
(11 citation statements)
references
References 71 publications
2
8
0
1
Order By: Relevance
“…Density and refractive index measurements were used to check the purity of the substances with a close agreement between the measured and literature data. As can be seen from Table , the obtained experimental physicochemical data lie within the range of the literature values. The observed differences between the measured and reported data fall inside the expected uncertainties of both measured and reported values.…”
Section: Methodssupporting
confidence: 60%
“…Density and refractive index measurements were used to check the purity of the substances with a close agreement between the measured and literature data. As can be seen from Table , the obtained experimental physicochemical data lie within the range of the literature values. The observed differences between the measured and reported data fall inside the expected uncertainties of both measured and reported values.…”
Section: Methodssupporting
confidence: 60%
“…For smaller molar mass, as it is the case of PEG 600 (average molar mass of 600 g mol −1 ), available data correspond mainly to properties for the liquid phase only. For instance, density measurements are provided by several authors [15,16,17,18], but they are given only for the liquid phase for few temperature values, not sufficient to obtain the thermal expansion coefficient. Some properties of PEG 600 are also given by Lane [19] who focuses on properties of several PCMs.…”
Section: Introductionmentioning
confidence: 99%
“…The fluorescence intensity ratio I 470/400 of excimer emission (at 470 nm) and monomer emission (at 400 nm) was measured as a function of (D) the solvent polarity parameter E T (30) and (E) the viscosity of methanol/PEG 600 mixtures ([Pyr-A] = 1.0 μM; excitation wavelength, 358 nm). Viscosities of the solvent mixtures were calculated from the molar fraction of PEG 600, based on the relationship reported previously ( Mousavi et al., 2020 ). …”
Section: Resultsmentioning
confidence: 99%
“…The excimer emission was more prominent in polar aprotic solvents with lower viscosities, such as acetonitrile (3.4 × 10 −4 Pa∙s) and acetone (3.0 × 10 −4 Pa∙s), than in more polar protic solvents with higher viscosities, such as 1-propanol (2.8 × 10 −3 Pa∙s) and 1-octanol (7.4 × 10 −3 Pa∙s). The influence of solvent viscosity was examined for binary mixtures of methanol and polyethylene glycol 600 (PEG 600), whose viscosities increase monotonically as a function of the molar fraction of PEG 600 ( Mousavi et al., 2020 ), but whose E T (30) values remain almost unchanged (54.2–55.4). The value of I 470/400 was found to decrease with increasing viscosity of the solvent mixtures ( Figure 2 E), indicating that the ratio of monomer and excimer fluorescence emissions of Pyr-A is sensitive to both the polarity and viscosity of its surrounding environment.…”
Section: Resultsmentioning
confidence: 99%