Threshold Pressure Phenomena in Porous Media

Abstract

Threshold displacement pressures are needed to determine how much overpressure can be used in storing natural gas. An experimental technique for determining threshold pressures by displacing water with gas from samples saturated with water is presented. Threshold pressures for eight low permeability samples were measured. Threshold pressure data obtained in this work, plus data on higher permeability samples reported in the literature, are correlated with porosity, permeability, surface tension and formation resistivity factor, Mercury injection pressures also were measured and correlated with air-water threshold pressures. Threshold pressures were found to be independent of time. An aerial photograph of gas emerging from The top of a core shortly after its threshold pressure has been exceeded shows that the gas bubbles we uniformly distributed across the face of the core. Channeling will occur, however, when an increased gas phase permeability is reached. A porous medium can be resealed after its threshold pressure has been reached provided it has not been desaturated below a fixed saturation. Its new threshold pressure will be lower than when the sample is 100 percent saturated with water. Introduction The degree of overpressure in excess of the discovery pressure that a gas storage reservoir can withstand is determined by the ability of its caprock to contain gas, providing the pressure does not exceed the structural limit of the reservoir. The retention of gas in a reservoir by a caprock saturated with water is a result of the capillary forces acting at the gas water interface. Without the presence of water in a caprock, gas would leak out of the reservoir at a rate determined by the permeability of the caprock to gas. The ability of a caprock to contain gas is expressed in terms of its threshold displacement pressure, which is defined as the minimum pressure needed to initiate the displacement of a wetting phase by a nonwetting phase from a porous medium 100 percent saturated with the wetting phase. The gas industry must be able to predict how much "overpressure" a gas reservoir can withstand before leakage occurs by gas displacing water from caprock overlying the reservoir. This is of economic importance since the storage capacity of a gas reservoir is proportional to its pressure. The discovery pressure for most reservoirs is found between the upper and lower limits shown in Fig. 1. Discovery pressures in excess of their hydraulic pressure gradient are attributed to the compaction of an isolated shale formation by the overburden. The lower limit of 0.433 psi/ft corresponds to the weight of the overburden, the gradient of the rock itself. SPEJ P. 174ˆ

Advanced and Integrated Petrophysical Characterization for CO2Storage: Application to the Ketzin Site

“…This is similar to the empirical relationship proposed by Thomas et al (1968). If the confinement reduces the pore mean diameter d and does not affect the internal structure or connectivity of the porous structure, relation (15) is valid.…”

Numerical investigation of methane and formation fluid leakage along the casing of a decommissioned shale gas well

“…Due to lack of data for the capillary and displacement properties, the semianalytical correlations of Huet et al [2005], which relate the Brooks and Corey model parameters to porosity and permeability, were used to determine the values of the gas entry pressure p e and the pore size distribution index k. Similar values of the gas entry pressure p e were also obtained using the empirical models of Thomas et al [1968] and Hawkins et al [1993]. Since no data were available for the irreducible liquid and residual gas saturations in the Utica shale and Lorraine Group, they were assumed equal to 20% and 0%, respectively, for all simulations.…”

What’s Conventional and What’s Special in a Reservoir Study for Underground Gas Storage

“…Regardless from the adopted experimental procedure, threshold pressure evaluation via lab analysis is always time-consuming (in the order of days or even weeks) due to the poor fluid transport property of the tested fine-grained caprocks. Consequently, different experimental and theoretical relations between threshold pressure values and petrophysical rock properties, such as permeability, porosity and formation resistivity, have also been developed [15][16][17]. However, even if these correlations represent a cheap and prompt alternative for a first-guess parameter estimation, only lab analyses can provide a reliable threshold pressure evaluation.…”