Viscosity Measurement in a Lubricant Film Using an Ultrasonically Resonating Matching Layer

Abstract

A novel ultrasonic viscometer intended for in-situ applications in lubricated components is presented. The concept is based on the reflection of a shear wave at a solid-liquid boundary that depends on the viscosity of the liquid and the acoustic properties of the solid. Very little ultrasound energy can propagate into the oil at a metal-oil interface because the acoustic mismatch is great, and this leads to large measurement errors. The method described in this paper overcomes this limitation by placing a thin intermediate matching layer between the metal and the lubricant.Results obtained with this technique are in excellent agreement with expected values from conventional viscometers when Newtonian mineral oils are analysed. When complex non-Newtonian mixtures are tested the viscosity measurement is frequency dependent. At high ultrasonic frequencies, over 1 MHz, it is possible to shear only the base oil, while to obtain the viscosity of the mixture it is necessary to choose a lower excitation frequency to match the dispersed polymer relaxation time.

An Ultrasonic Rheometer to Measure Gas Absorption in Ionic Liquids: Design, Calibration and Testing

“…The materials and bonding procedures are executed as in stage 1; however, the geometry includes an NPT 1/8 thread to allow mounting on the test reactor as shown in the next section. Further a front face of polymeric material 50-μm-thick is added as quarter wavelength acoustic lens to enhance the ultrasonic response sensitivity [ 52 ].…”

In situ Measurement of Journal Bearing Lubricant Viscosity by Means of a Novel Ultrasonic Measurement Technique Using Matching Layer

“…The theory and operating principles of this ultrasonic viscometer have been described in detail in a previous work [1]. This section focuses, then, on presenting the use of this viscometer and on how to select appropriately the matching layers for automotive applications.…”

“…This thickness was calculated using equation (8) and (10) for a resonance frequency of 4.5 MHz. The combination of aluminium and polyimide was found to be ideal for maximizing the measurement sensitivity, while minimizing the measurement noise [1]. The ultrasonic plug was press fitted into the steel journal of the tested journal bearing.…”

“…Very little ultrasonic energy can propagate into the oil at a metal-oil interface because the acoustic mismatch is significant. Interleaving a matching layer between the metal and the lubricant enables accurate ultrasonic viscosity measurements [1]. This technique has been used to build a miniaturized ultrasonic viscometer that is accommodated inside a journal to obtain the circumferential viscosity profile.…”

Quantitative Viscosity Mapping Using Fluorescence Lifetime Measurements

“…Techniques such as ultrasonic shear reflection [11] are limited by spatial resolution. However, recent improvements through the use of the matching layer method mean that where high spatial resolution is not an requirement, then this technique can be used to measure the viscosity in thin films [12]. Spectroscopic techniques provide the best approach for high spatial resolution measurements.…”