Wavelet Analysis for Evaluating the Length of Precast Spliced Piles Using Low Strain Integrity Testing

Abstract

The difficulties with the application of low strain integrity testing for evaluating the length of driven precast piles of two sections justify the need for new data acquisition and analysis techniques. The standard time domain analysis of the recorded signals may not allow for distinguishing the desired responses from a pile toe and a splice. In this paper, we propose the use of a set of hammers of different weights and tip materials that will provide various sensitivities of the test to a pile splice. To further analyze the collected data, we study the distributions of phase angles obtained using complex continuous wavelet transform. The characteristic phase shifts that distribute from higher to lower frequencies can be interpreted as responses from a pile toe and a splice. To verify the proposed approaches, a series of numerical simulations were performed using the finite element method for the driven pile models with the different properties of a splice zone. Numerical simulation results show that the pile splices are clearly identified when using the shorter input pulses which can be generated by light hammers with a hard head material. The total length of a simulated pile with a 1 mm air gap between sections was undetectable by standard data analysis approaches and was evaluated when analyzing the wavelet phase angle distributions. Numerically validated data acquisition and analysis techniques were applied to field data analysis and allowed us to confidently identify the length of two-section piles grouped with a pile cap.

Research on Image Denoising in Edge Detection Based on Wavelet Transform

“…In general, the threshold function can be selected as either a hard or soft threshold function, both of which have advantages and disadvantages. Hard threshold functions are better than soft threshold functions in the sense of mean squared deviation, but they may produce jump points, while soft threshold functions have better continuity but produce biases that affect the reconstructed signal [5,[24][25][26]. The hard threshold function working process is shown in Figure 5.…”

Numerical Simulation of Nonlinear Processes in the “Thruster—Downhole Motor—Bit” System While Extended Reach Well Drilling

“…The flow restriction ratio is determined by: The compression ratio during the passage of the drilling mud flow through the holes of the diaphragm (according to the Altshul empirical formula) [36] is calculated by:…”

Research on Image Denoising in edge detection Based on Wavelet Transform

“…Hard thresholding has advantages in the sense of mean squared deviation. Soft thresholding functions, however, may produce jump points, while soft thresholding functions have better continuity but produce biases that affect the reconstructed signal [5,[23][24][25][26] . In this paper a hard thresholding function is chosen to process the coefficients, followed by wavelet reconstruction.…”