What experimental factors influence the accuracy of retention projections in gas chromatography–mass spectrometry?

Abstract

Programmed-temperature gas chromatographic (GC) retention information is difficult to share because it depends on so many experimental factors that vary among laboratories. Though linear retention indexing cannot properly account for experimental differences, retention times can be accurately calculated, or “projected”, from shared isothermal retention vs. temperature (T) relationships, but only if the temperature program and hold-up time vs. T profile produced by a GC is known with great precision. The effort required to measure these profiles were previously impractical, but we recently showed that they can be easily back-calculated from the programmed-temperature retention times of a set of 25 n-alkanes using open-source software at www.retentionprediction.org/gc. In a multi-lab study, the approach was shown to account for both intentional and unintentional differences in the temperature programs, flow rates, and inlet pressures produced by the GCs. Here, we tested 16 other experimental factors and found that only 5 could reduce accuracy in retention projections: injection history, exposure to very high levels of oxygen at high temperature, a very low transfer line temperature, an overloaded column, and a very short column (≤ 15 m). We find that the retention projection methodology acts as a hybrid of conventional retention projection and retention indexing, drawing on the advantages of both; it properly accounts for a wide range of experimental conditions while accommodating the effects of experimental factors not properly taken into account in the calculations. Finally, we developed a four-step protocol to efficiently troubleshoot a GC system after it is found to be yielding inaccurate retention projections.

United Nations Office on Drugs and Crime: Recommended methods for the Identification and Analysis of Synthetic Cannabinoid Receptor Agonists in Seized Materials

“…All compounds identified by GC-MS ideally should be compared to a current mass spectrum of the appropriate reference standard, preferably obtained from the same instrument, operated under the same conditions. When a reference standard is not analysed concurrently with the sample, one can make use of various chromatographic techniques such as retention time locking [ 41 ], relative retention time [ 42 ] or retention index [ 43 ] to minimize any variation in the retention time of the analyte.…”

Using GC-MS for natural product analysis in Nigeria: Problems and prospects

“…Similarly, air currents from a fan or air conditioner blowing across the top of the instrument may interfere with gas exiting from the detector and a contaminated detector results in noise. When noise increases gradually to an unacceptable level, it indicates a gradual buildup of the noise source, rather than an abrupt change [39,40].…”