The silicon pixel tracking system for the ATLAS experiment at the Large Hadron Collider is described and the performance requirements are summarized. Detailed descriptions of the pixel detector electronics and the silicon sensors are given. The design, fabrication, assembly and performance of the pixel detector modules are presented. Data obtained from test beams as well as studies using cosmic rays are also discussed.

No abstract

No abstract

The Cryogenic Dark Matter Search (CDMS) employs Ge and Si detectors to search for weakly interacting massive particles (WIMPs) via their elastic-scattering interactions with nuclei while discriminating against interactions of background particles. CDMS data, accounting for the neutron background, give limits on the spin-independent WIMP-nucleon elastic-scattering cross section that exclude unexplored parameter space above 10 GeV͞c 2 WIMP mass and, at .75% C.L., the entire 3s allowed region for the WIMP signal reported by the DAMA experiment. Extensive evidence indicates that a large fraction of the matter in the universe is nonluminous, nonbaryonic, and "cold"-nonrelativistic at the time matter began to dominate the energy density of the universe [1][2][3]. Weakly interacting massive particles (WIMPs) are an excellent candidate for nonbaryonic, cold dark matter [2,4]. Minimal supersymmetry provides a natural WIMP candidate in the form of the lightest superpartner, with a typical mass M ϳ 100 GeV͞c 2 [5][6][7][8]. WIMPs are expected to have collapsed into a roughly isothermal, spherical halo within which the visible portion of our galaxy resides. WIMPs scatter off nuclei via the weak interaction, potentially allowing their direct detection [9,10]. The expected spectrum of recoil energies (energy given to the recoiling nucleus during the interaction) is exponential with a characteristic energy of a few to tens of keV [11]. The expected event rate is model dependent, but is generically 1 kg 21 d 21 or lower [10]. This Letter reports new exclusion limits on the spinindependent WIMP-nucleon elastic-scattering cross section by the Cryogenic Dark Matter Search (CDMS). The rate of rare WIMP-nucleon interactions is constrained by extended exposure of detectors that discriminate WIMPinduced nuclear recoils from electron recoils caused by interactions of background particles [12,13].The ionization yield Y (the ratio of ionization production to recoil energy in a semiconductor) of a particle interaction differs greatly for nuclear and electron recoils. CDMS detectors measure phonon and electron-hole pair production to determine recoil energy and ionization yield for each event. The data discussed here were obtained with two types of detectors, Berkeley Large Ionization-and Phonon-mediated (BLIP) and Z-sensitive Ionization-and Phonon-mediated (ZIP) detectors [12][13][14][15][16][17][18]. For both types, the drift field for the ionization measurement is supplied by radially segmented electrodes on the faces of the disk-shaped crystals [19]. In BLIP detectors, phonon production is determined from the detector's calorimetric temperature change. In ZIP detectors, athermal phonons are collected to determine phonon production and xy position. Detector performance is discussed in detail elsewhere [14,[16][17][18][19][20].Photons cause most bulk electron recoils, while lowenergy electrons incident on the detector surfaces cause low-Y electron recoils in a thin surface layer ("surface events"). Neutron, photon, and electron sources a...

This paper describes the evaporative system used to cool the silicon detector structures of the inner detector sub-detectors of the ATLAS experiment at the CERN Large Hadron Collider. The motivation for an evaporative system, its design and construction are discussed. In detail the particular requirements of the ATLAS inner detector, technical choices and the qualification and manufacture of final components are addressed. Finally results of initial operational tests are reported. Although the entire system described, the paper focuses on the on-detector aspects. Details of the evaporative cooling plant will be discussed elsewhere.