Highly peaked density and pressure profiles in a new operating regime have been observed on the Tokamak Fusion Test Reactor (TFTR). The qprofile has a region of reversed magnetic shear extending from the magnetic axis to r / u-0.3-0.4. The central electron density rises from 0.45 x lo2' m-3 to nearly 1.2 x lo2' m-' during neutral beam injection. The electron particle diffusivity drops precipitously in the plasma core with the onset of the improved confinement mode and can be reduced by a factor of N 50 to near the neoclassical particle diffusivity level.

After many years of fusion research, the conditions needed for a D–T fusion reactor have been approached on the Tokamak Fusion Test Reactor (TFTR) [Fusion Technol. 21, 1324 (1992)]. For the first time the unique phenomena present in a D–T plasma are now being studied in a laboratory plasma. The first magnetic fusion experiments to study plasmas using nearly equal concentrations of deuterium and tritium have been carried out on TFTR. At present the maximum fusion power of 10.7 MW, using 39.5 MW of neutral-beam heating, in a supershot discharge and 6.7 MW in a high-βp discharge following a current rampdown. The fusion power density in a core of the plasma is ≊2.8 MW m−3, exceeding that expected in the International Thermonuclear Experimental Reactor (ITER) [Plasma Physics and Controlled Nuclear Fusion Research (International Atomic Energy Agency, Vienna, 1991), Vol. 3, p. 239] at 1500 MW total fusion power. The energy confinement time, τE, is observed to increase in D–T, relative to D plasmas, by 20% and the ni(0) Ti(0) τE product by 55%. The improvement in thermal confinement is caused primarily by a decrease in ion heat conductivity in both supershot and limiter-H-mode discharges. Extensive lithium pellet injection increased the confinement time to 0.27 s and enabled higher current operation in both supershot and high-βp discharges. Ion cyclotron range of frequencies (ICRF) heating of a D–T plasma, using the second harmonic of tritium, has been demonstrated. First measurements of the confined alpha particles have been performed and found to be in good agreement with TRANSP [Nucl. Fusion 34, 1247 (1994)] simulations. Initial measurements of the alpha ash profile have been compared with simulations using particle transport coefficients from He gas puffing experiments. The loss of alpha particles to a detector at the bottom of the vessel is well described by the first-orbit loss mechanism. No loss due to alpha-particle-driven instabilities has yet been observed. D–T experiments on TFTR will continue to explore the assumptions of the ITER design and to examine some of the physics issues associated with an advanced tokamak reactor.

The electron temperature profile response in ohmically heated Tokamak Fusion Test Reactor (TFTR) discharges to temporally and spatially sharp edge cooling from laser ablation of trace impurities is studied. The profile response is found to exhibit transport behaviour which cannot be described by transport coefficients that depend solely on local parameters. Thus, the transport behaviour is 'non-local'. This non-local behaviour manifests itself as a core electron temperature rise in response to localized edge cooling as well as transient modification of sawteeth. A phenomenological model demonstrating overlapping non-local and non-linear effects is presented in the context of some alternative transport theories. Carbon flakes falling from the TFTR wall into a low power deuterium-tritium supershot produce this same core electron temperature rise. This paper complements observations by Gentle et al. (Gentle, K.W., et al., Phys. Rev. Lett. 74 (1995) 3620).

A transport code (TRANSP) is used to simulate future deuterium-tritium (DT) experiments in TFTR. The simulations are derived from 14 TFTR DD discharges, and the modelling of one supershot is discussed in detail to indicate the degree of accuracy of the TRANSP modelling. Fusion energy yields and 01 particle parameters are calculated, including profiles of the 01 slowing down time, the 01 average energy, and the AlfvBn speed and frequency. Two types of simulation are discussed. The main emphasis is on the DT equivalent, where an equal mix of D and T is substituted for the D in the initial target plasma, and for the Do in the neutral beam injection, but the other measured beam and plasma parameters are unchanged. This simulation does not assume that 01 heating will enhance the plasma parameters or that confinement will increase with the addition of tritium. The maximum relative fusion yield calculated for these simulations is QDT-0.3, and the maximum a contribution to the central toroidal 0 is PJO)-0.5%. The stability of toroidicity induced Alfvkn eigenmodes (TAE) and kinetic ballooning modes (KBM) is discussed. The TAE mode is predicted to become unstable for some of the simulations, particularly after the termination of neutral beam injection. In the second type of simulation, empirical supershot scaling relations are used to project the performance at the maximum expected beam power. The MHD stability of the simulations is discussed.