No abstract

A glassy carbon electrode (GCE) was modified with nanosize poly (3-methylthiophene) (P3MT) and used for the sensitive voltammetric determination of diazepam. The cyclic voltammetric response of the bare GCE was compared with the P3MT modified electrode. Electrochemical impedance response of diazepam on modified GCE was studied by various concentrations of diazepam from 0.2 μM to 0.6 μM. The poly (3-methylthiophene) modified glassy carbon electrode (P3MT/GCE) can greatly enhance the peak currents and the detection sensitivity of diazepam under optimal conditions. The quantitative analysis of diazepam was made by the DPSV method. The experimental results showed that the peak current increased with the increase in concentration of diazepam. A calibration was made, which indicated the linear dependence of peak current with concentration (ip = 13.31Conc. + 0.4359R2 = 0.9948) in the range od determination and ot was found to be good between 0.2 and 1.07 μg/L. The limit of detection was 0.1μg/mL. The reproducibility of the stripping signal was realized in terms of relative standard deviation for 6 identical measurements and was found to be 2.6%. The effect of interference of different cations and anions on the oxidation of diazepam was studied. Real sample analysis of diazepam was also studied through DPSV.

No abstract

Medicinal plants are the  sources of medicine. To determine the anti-bacterial effect of synthesized silver nanoparticles using Capsicum on Staphylococcus aureus and Klebsiella pneumoniae. The objective of the study was to determine the effect of different concentration extracts of Capsicum  annuum  (red bell pepper, green bell pepper and yellow bell pepper). The extract from Capsicum showed a higher antibacterial activity against  Klebsiella pneumoniae followed by Staphylococcus aureus. The extract had higher percentages of inhibition with increased concentration  of red and yellow bell pepper.

Nano particles of Copper oxide and Poly(3,4-ethylenedioxythiophene)-Copper oxide nanocomposite were prepared by chemical oxidation method. The formed metal oxide nanoparticle and polymer metal oxide nanocomposites were characterized by UV–VIS, XRD, SEM and EIS studies. The UV-VIS studies of nanoparticles and nanocomposites exhibited four peaks, two peaks are sharp and centered at 280nm and 360 nm while the other two were broaden waves obtained at 780nm and 985nm. SEM image of copper oxide nanoparticles and nanocomposite exhibits sponge-like morphologies, in addition to nanospheres, nanowires, and nanotube shapes. The grain size of the metal oxide nanoparticle and polymer metaloxide nanocomposites was calculated using Scherrer’s formula. Electrochemical impedance spectroscopy (EIS) studies revealed the high conductivity nature due to the increased surface area of the nanocomposites.