No abstract

A wideband perforated rectangular dielectric resonator antenna (RDRA) reflectarray is presented. The array of RDRA are formed from one piece of material. Air-filled holes are drilled into the material around the RDRA. This technique of fabricating RDRA reflectarray using perforations eliminates the need to position and bond individual elements in the reflectarray and makes the fabrication of the RDRA reflectarray feasible. The ground plane below the reflectarray elements is folded to form a central rectangular concave dip so that an air-gap is formed between the RDRA elements and the ground plane in order to increase the bandwidth. Full-wave analysis using the finite integration technique is applied. Three cases are studied. In the first one, the horn antenna is placed at the focal point to illuminate the reflectarray and the main beam is in the broadside direction. In the second one, the horn antenna is placed at the focal point and the main beam is at ±30 degrees off broadside direction. In the third one, an offset feed RDRA reflectarray is considered. A variable length RDRA provides the required phase shift at each cell on the reflectarray surface. The normalized gain patterns, the frequency bandwidth, and the aperture efficiency for the above cases are calculated.

No abstract

a new type of dielectric resonator reflectarray composed of 529 elements covering an area of 276 x 276 cm 2 is constructed. The unit cell consists of squared DRA supported on a strip with variable slot length, a dielectric layer and a conducting ground plane. The full phase of 360 degree of the array elements can be obtained by superposition two slot-strip sizes. Two types of feeding were analyzed, the first is center fed reflectarray while the second is offset feed to reduce the feeder blockage and as a result the antenna efficiency is improved. The antenna has 10% bandwidth for 1 dB gain variation is obviously wider than that of conventional reflectarray antenna while the offset fed reflectarray provide better far field pattern with back lobes reduction by -5 dB and side lobe by -2 dB. A rectangular X-band pyramidal horn was used in both reflectarrays which have 23 x 23 elements of with cells separation of 12 mm that less than 15 mm (lambda/2) for avoiding grating lobes. CST microwave studio © (finite integral technique) package is applied and compared with microstripes © package (transmission line technique) with good agreements between them. The mutual coupling between the feeding horn and the elements of the reflectarray are considered. At 10 GHz, the antenna provides a 3-dB beamwidth of 6 degree with a gain of 28 dB. The antenna bandwidth within 1dB gain variation is found to be 13% and aperture efficiency of 59%.

A reflectarray antenna consists of elements of rectangular dielectric resonator (DRA) with slot loading of different lengths is proposed for bandwidth enhancement. Two DRA sizes an two slot widths are available to tune the phase of each element in the reflectarray so that a full 360 degrees phase shifts can be achieved by superposition. Two structures are presented in that paper. The first is center fed reflectarray while the second is offset fed for decreasing the feeder blockage. The antenna has 10% bandwidth for 1 dB gain variation is obviously wider than that of conventional reflectarray antenna while the offset fed reflectarray provide better far field pattern with back lobes reduction by -5 dB and side lobe by -2 dB. A pyramidal X-band horn was used in both reflectarrays which have 23 x 23 elements of with cells separation of 12 mm that less than 15 mm (lambda/2) for avoiding grating lobes. The analyses are carried out using the finite integration technique (FIT) and the transmission line method (TLM) with good agreements between them.