No abstract

No abstract

The paper describes the technology of manufacturing a thin nickel-titanium wire through direct exposure to infrared radiation (IR). The effect of IR on the change in the structure of a thin wire made from the TiNi-based alloy was studied during its manufacturing. A comparative analysis of the Ti, Ni and O concentration in the TiNi wire was carried out. The analysis was performed for both a thin wire exposed to infrared radiation and that not exposed to infrared radiation. The wire samples were studied using a scanning electron microscope with the energy dispersive analysis. The infrared radiation effect on the structure of the wire is shown after thermal treatment in the local area of the material.

No abstract

The paper addresses the production and investigation of the Mg–Ca–Zn alloy dispersion-hardened by diamond nanoparticles. Structural studies have shown that diamond nanoparticles have a modifying effect and make it possible to reduce the average grain size of the magnesium alloy. Reduction of the grain size and introduction of particles into the magnesium matrix increased the yield strength, tensile strength, and ductility of the magnesium alloy as compared to the original alloy after vibration and ultrasonic treatment. The magnesium alloy containing diamond nanoparticles showed the most uniform fracture due to a more uniform deformation of the alloy with particles, which simultaneously increased its strength and ductility.