The remarkable properties of atomically-thin semiconducting TMD layers include an indirect-to-direct bandgap crossover 1, 2, 9 , field-induced transport with high on-off ratios 16 , 3 valley selective circular dichroism [3][4][5][6] , and strong photovoltaic response 17,18 . Fundamental understanding of the electron/hole quasiparticle band structure and many-body interactions in 2D TMDs, however, is still lacking. Enhanced Coulomb interactions due to low-dimensional effects are expected to increase the quasiparticle bandgap as well as to cause electron-hole pairs to form more strongly bound excitons [10][11][12][13] . Untangling such many-body effects in single-layer TMDs requires measurement of both the electronic bandgap and the optical bandgap, the most fundamental parameters for transport and optoelectronics, respectively. The electronic bandgap (E g ) characterizes single-particle (or quasiparticle) excitations and is defined by the sum of the energies needed to separately tunnel an electron and a hole into monolayer MoSe 2 . The optical bandgap (E opt ), on the other hand, describes the energy required to create an exciton, a correlated two-particle electron-hole pair, via optical absorption. The difference in these energies (E g -E opt ) directly yields the exciton binding energy (E b ) (Fig. 2a). Here we provide evidence for Coulomb driven quasiparticle bandgap renormalization and unusually strong exciton stability in 2D TMD through direct determination of both E g and E opt via STS and PL spectroscopy, respectively. STS and PL measurements were carried out on the same high-quality sub-monolayer MoSe 2 films grown on epitaxial bilayer graphene (BLG) on a 6H-SiC(0001) substrate.Because the MoSe 2 surface coverage for our sample was ~ 0.8 ML, we were able to simultaneously image the MoSe 2 monolayer and the underlying graphene substrate using scanning tunneling microscopy (STM). We experimentally investigated both the electronic structure and the optical transitions in monolayer MoSe 2 /BLG by combining STS and PL spectroscopy. Fig. 2b shows a typical STM dI/dV spectrum acquired on monolayer MoSe 2 /BLG. The observed electronic structure is dominated by a large electronic bandgap surrounded by features labeled V 1-4 in the valence band (VB) and C 1 in the conduction band (CB). The MoSe 2 band edges are best determined by taking the logarithm of dI/dV, as shown in Fig. 2d.There the VB maximum (VBM) for monolayer MoSe 2 is seen to be located at -1.55 ± 0.03 V and the CB minimum (CBM) at 0.63 ± 0.02 V. The relative position of E F (V bias = 0 V) with respect to the band edges reveals n-type doping for our samples, although with 5 a very low carrier concentration. We tentatively attribute the n-doping of our MoSe 2 samples to intrinsic point defects such as vacancies and/or lattice antisites, which have been found to be responsible for n-doping in similar materials 20 . Our STS measurements yield a value for the single-particle electronic bandgap of E g = E CBM -E VBM = 2.18 eV ± 0.04 eV. The uncertainty ...

Layered transition metal dichalcogenides (TMDs) are ideal systems for exploring the effects of dimensionality on correlated electronic phases such as charge density wave (CDW) order and superconductivity. In bulk NbSe2 a CDW sets in at TCDW = 33 K and superconductivity sets in at Tc = 7.2 K. Below Tc these electronic states coexist but their microscopic formation mechanisms remain controversial. Here we present an electronic characterization study of a single 2D layer of NbSe2 by means of low temperature scanning tunneling microscopy/spectroscopy (STM/STS), angle-resolved photoemission spectroscopy (ARPES), and electrical transport measurements. We demonstrate that 3x3 CDW order in NbSe2 remains intact in 2D. Superconductivity also still remains in the 2D limit, but its onset temperature is depressed to 1.9 K. Our STS measurements at 5 K reveal a CDW gap of  = 4 meV at the Fermi energy, which is accessible via STS due to the removal of bands crossing the Fermi level for a single layer. Our observations are consistent with the simplified (compared to bulk) electronic structure of single-layer NbSe2, thus providing new insight into CDW formation and superconductivity in this model strongly-correlated system.

High quality WSe2 films have been grown on bilayer graphene (BLG) with layer-by-layer control of thickness using molecular beam epitaxy. The combination of angle-resolved photoemission, scanning tunneling microscopy/spectroscopy, and optical absorption measurements reveal the atomic and electronic structures evolution and optical response of WSe2/BLG. We observe that a bilayer of WSe2 is a direct bandgap semiconductor, when integrated in a BLG-based heterostructure, thus shifting the direct-indirect band gap crossover to trilayer WSe2. In the monolayer limit, WSe2 shows a spin-splitting of 475 meV in the valence band at the K point, the largest value observed among all the MX2 (M = Mo, W; X = S, Se) materials. The exciton binding energy of monolayer-WSe2/BLG is found to be 0.21 eV, a value that is orders of magnitude larger than that of conventional three-dimensional semiconductors, yet small as compared to other two-dimensional transition metal dichalcogennides (TMDCs) semiconductors. Finally, our finding regarding the overall modification of the electronic structure by an alkali metal surface electron doping opens a route to further control the electronic properties of TMDCs.

Chemical transformations at the interface between solid/liquid or solid/gaseous phases of matter lie at the heart of key industrial-scale manufacturing processes. A comprehensive study of the molecular energetics and conformational dynamics that underlie these transformations is often limited to ensemble-averaging analytical techniques. Here we report the detailed investigation of a surface-catalysed cross-coupling and sequential cyclization cascade of 1,2-bis(2-ethynyl phenyl)ethyne on Ag(100). Using non-contact atomic force microscopy, we imaged the single-bond-resolved chemical structure of transient metastable intermediates. Theoretical simulations indicate that the kinetic stabilization of experimentally observable intermediates is determined not only by the potential-energy landscape, but also by selective energy dissipation to the substrate and entropic changes associated with key transformations along the reaction pathway. The microscopic insights gained here pave the way for the rational design and control of complex organic reactions at the surface of heterogeneous catalysts.

Despite the weak nature of interlayer forces in transition metal dichalcogenide (TMD) materials, their properties are highly dependent on the number of layers in the few-layer two-dimensional (2D) limit. Here, we present a combined scanning tunneling microscopy/spectroscopy and GW theoretical study of the electronic structure of high quality single- and few-layer MoSe2 grown on bilayer graphene. We find that the electronic (quasiparticle) bandgap, a fundamental parameter for transport and optical phenomena, decreases by nearly one electronvolt when going from one layer to three due to interlayer coupling and screening effects. Our results paint a clear picture of the evolution of the electronic wave function hybridization in the valleys of both the valence and conduction bands as the number of layers is changed. This demonstrates the importance of layer number and electron–electron interactions on van der Waals heterostructures and helps to clarify how their electronic properties might be tuned in future 2D nanodevices.