This study investigates the possibility of applying an adsorption process using two abundant natural minerals M1 and M2. Without pretreatment or activation, the adsorbents were used to treat real textile wastewater samples (collected from Fez city, Morocco). As a cost-effective alternative, these materials were characterized by different analyses, including X-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), and X-ray fluorescence (XRF). Chemical oxygen demand (COD) and biological oxygen demand (BOD) were used to characterize the textile wastewater. Additionally, the influence of operating conditions (contact time, adsorbent dosages, and pH) was evaluated. Results show that the adsorption process takes place quickly, reaching the equilibrium at 90 and 160 min for M1 (88% COD) and M2 (79% COD). Both materials show a higher affinity to Cr (39%) and lower affinity to Cu (28%). A pseudo-second-order kinetic model provides the best fit to the experimental adsorption data. Germination tests indicate a low toxicity after the adsorption process. Performance of both materials was compared with that of other literature studies.

The objective of this study is to evaluate the efficiency of methylene blue removal using Oued Sebou sediments as an adsorbent. The presence of carboxyl functional group demonstrated by infrared (IR) analysis of the sediment favorized the methylene blue (MB) adsorption. Sediment collected from Oued Sebou could remove the most MB molecules at pH 8. The Freundlich model described suitably the adsorption process. The experimental measured enthalpy (ΔH) and entropy (ΔS°) are 118.1 kJ mol−1 and 395.2 J mol−1 K−1, respectively, indicating that the reaction was endothermic with an increase of randomness at the solid/liquid interface during the adsorption. The kinetics of MB adsorption by sediment were adequately fitted to the pseudo-second-order model. Experimental results showed that the adsorption capacity of the methylene blue dye depends on the solution pH, the initial dye concentration, the adsorbent mass, the sediment particle diameter, and the temperature of the reaction medium. The removal efficiency of the MB molecules reaches 100% after 60 minutes under the optimum conditions.

In this work, the adsorption of Remazol Brilliant Blue (RBB) over raw date pits (RDPs) as an inexpensive adsorbent has been examined. In addition, all parameters such as the adsorbent mass, solution pH, RDP particle size, RBB initial concentration, and temperature on the adsorption of RBB influencing the adsorption procedure were studied to provide fundamental information of the adsorption equilibrium. The characterization of RDP material is investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), and Fourier-transform infrared spectroscopy (FTIR). Based on the calculation, the kinetic rate of the adsorption was well modeled by pseudo-second-order and Langmuir isotherm. Surface functional groups of RDP have substantially been influenced by the adsorption characteristics of RBB. The capacity of the adsorption has achieved 105 mg/g and a removal efficiency of 90.4% at 1.5 g/L RDP mass, 40 mg/L initial dye concentration, pH 2, temperature of 328 K, 40 µm particle size, and contact time of 50 min. The capacity of the adsorption could reach 198 mg/g by increasing the ionic strength of RBB solution. Desorption tests showed that RDP adsorbent has the disadvantage of losing efficiency while reusing for many cycles. However, it still abundant and inexpensive. Therefore, RDP can be used as a potential low-cost bioabsorbent for the elimination of RBB from wastewater.

No abstract

No abstract