Global navigation satellite system (GNSS) receivers use tracking loops to lock onto GNSS signals. Fixed loop settings limit the tracking performance against noise, receiver dynamics, and the current scenario. Adaptive tracking loops adjust these settings to achieve optimal performance for a given scenario. This paper evaluates the performance and complexity of state-of-the-art adaptive scalar tracking techniques used in modern digital GNSS receivers. Ideally, a tracking channel should be adjusted to both noisy and dynamic environments for optimal performance, defined by tracking precision and loop robustness. The difference between the average tracking jitter of the discriminator’s output and the square-root Cramér-Rao bound (CRB) indicates the loops’ tracking capability. The ability to maintain lock characterizes the robustness in highly dynamic scenarios. From a system perspective, the average lock indicator is chosen as a metric to measure the performance in terms of precision, whereas the average number of visible satellites being tracked indicates the system’s robustness against dynamics. The average of these metrics’ product at different noise levels leads to a reliable system performance metric. Adaptive tracking techniques, such as the fast adaptive bandwidth (FAB), the fuzzy logic (FL), and the loop-bandwidth control algorithm (LBCA), facilitate a trade-off for optimal performance. These adaptive tracking techniques are implemented in an open software interface GNSS hardware receiver. All three methods steer a third-order adaptive phase locked loop (PLL) and are tested in simulated scenarios emulating static and high-dynamic vehicular conditions. The measured tracking performance, system performance, and time complexity of each algorithm present a detailed analysis of the adaptive techniques. The results show that the LBCA with a piece-wise linear approximation is above the other adaptive loop-bandwidth tracking techniques while preserving the best performance and lowest time complexity. This technique achieves superior static and dynamic system performance being 1.5 times more complex than the traditional tracking loop.

Interference can significantly degrade the performance of global navigation satellite system (GNSS) receivers. Therefore, mitigation methods are required to ensure reliable operations. However, as there are different types of interference, robust, multi-purpose mitigation algorithms are needed. This paper describes the most popular state-of-the-art interference mitigation techniques. The high-rate DFT-based data manipulator (HDDM) is proposed as a possible solution to overcome their limitations. This paper presents a hardware implementation of the HDDM algorithm. The hardware HDDM module is integrated in three different receivers equipped with analog radio-frequency (RF) front-ends supporting signals with different dynamic range. The resource utilization and power consumption is evaluated for the three cases. The algorithm is compared to a low-end mass-market receiver and a high-end professional receiver with basic and sophisticated interference mitigation capabilities, respectively. Different type of interference are used to compare the mitigation capabilities of the receivers under test. Results of the HDDM hardware implementation achieve the similar or improved performance to the state of the art. With more complex interferences, like frequency hopping or pulsed, the HDDM shows even better performance.

No abstract