No abstract

No abstract

Existing rating methods estimate bridge loading capacity and demand from secondary actions due to live loads in the primary structural components. In these methods, uniaxial yielding stress is traditionally used to detect component capacity using either stress quantities or shear-moment actions to compute the capacity demand of the bridge. These approximations can lead to uncertainties in load capacity estimation. This article presents the weight-over process (WOP), a novel computer-aided approach to bridge loading capacity evaluation based on tonnage and rating factor estimation. WOP is expected to capture different forms of failure in a more general manner than existing methods. In WOP, a bridge finite element model (FEM) is discretized into many sections and element sets, each containing a single material type, and each assigned a suitable 3D failure criterion. Then, factored gross vehicle weights (GVWs) are incrementally imposed on the bridge FEM with those predefined ultimate unfavored loading scenarios in a manner similar to proof load testing. WOP code runs nonlinear analysis at each increment until a stopping criterion is met. Two representative bridges were selected to confirm WOP’s feasibility and efficacy. The results showed that WOP-predicted values at the interior girders were between those of the conventional AASHTO and the nondestructive testing (NDT) strain measurement methods. That may put WOP in a favorable zone as a new method that is less conservative than AASHTO but more conservative than real NDT testing.

No abstract

This article presents a new analysis to determine the variation in modal dynamic characteristics of bridge superstructures caused by hydrodynamic added mass (HAM) during progressive flooding. The natural frequency variations were numerically and experimentally extracted in various artificial flood stages that included dry conditions, semi-wet conditions, and fully wet conditions. Three-dimensional finite element modeling of both subscale and full-scale models were simulated through a coupled acoustic structural technique using Abaqus®. Experiments were performed exclusively on a subscale model at a flume laboratory to confirm the numerical simulations. Finally, an approach to quantify the directional HAM in the dominant axes of vibration was pursued using the concept of effective modal mass. It is shown that specific vibrating modes with the largest effective mass are strongly affected during artificial flood events and are identified as the dominant modes. Numerical simulation shows that large directional HAM is introduced on those dominant modes during flood events. For the full-scale representative bridge, the magnitude of the HAM along the first structural mode was estimated to be over 5.8 times the bridge’s structural modal effective mass. It is suggested that directional HAM should be included during the design of bridges over streamways that are prone to flooding in order to potentially be appended to the AASHTO code.