This paper investigates comprehensive knowledge regarding joining CFRP and aluminium alloys in available literature in terms of available methods, bonding processing and mechanism and properties. The methods employed comprise the use of adhesive, self-piercing rivet, bolt, clinching and welding to join only CFRP and aluminium alloys. The non-thermal joining methods received great attention though the welding process has high potential in joining these materials. Except adhesive bonding and welding, other joining methods require the penetration of metallic pins through joining parts and therefore, surface preparation is unimportant. No model is found to predict the properties of jointed structures, which makes it difficult to select one over another in applications. The choice of bonding methods depends primarily on the specific applications. The load-bearing mechanism of bolted joints is predominantly the friction that is the first stage resistance. Hybrid joints performance is enhanced by combining rivets, clinch or bolts with adhesives.

No abstract

No abstract

This paper presents a mechanics model for predicting the forces of cutting aluminium-based SiC/Al 2 O 3 particle reinforced MMCs. The force generation mechanism was considered to be due to three factors: (a) the chip formation force, (b) the ploughing force, and (c) the particle fracture force. The chip formation force was obtained by using Merchant's analysis but those due to matrix ploughing deformation and particle fracture were formulated, respectively, with the aid of the slip line field theory of plasticity and the Griffith theory of fracture. A comparison of the model predictions with the authors' experimental results and those published in the literature showed that the theoretical model developed has captured the major material removal/deformation mechanisms in MMCs and describes very well the experimental measurements.

a b s t r a c tMachining forces, chip formation, surface integrity and shear and friction angles are important factors to understand the machinability of metal matrix composites (MMCs). However, because of the complexity of the reinforcement mechanisms of the ceramic particles, a fair assessment of the machinability of MMCs is still a difficult issue. This paper investigates experimentally the effects of reinforcement particles on the machining of MMCs. The major findings are: (1) the surface residual stresses on the machined MMC are compressive; (2) the surface roughness is controlled by feed;(3) particle pull-out influences the roughness when feed is low; (4) particles facilitate chip breaking and affect the generation of residual stresses; and (5) the shear and friction angles depend significantly on feed but are almost independent of speed. These results reveal the roles of the reinforcement particles on the machinability of MMCs and provide a useful guide for a better control of their machining processes.