Lahars are one of the greatest hazards at many volcanoes, including Volcán de Fuego (Guatemala). On 1 December 2018 at 8:00pm local Guatemala time (2:00:00 UTC), an hour-long lahar event was detected at Volcán de Fuego by two permanent seismo-acoustic stations along the Las Lajas channel on the southeast side. To establish the timing, duration, and speed of the lahar, infrasound array records were examined to identify both the source direction(s) and the correlated energy fluctuations at the two stations. Co-located seismic and acoustic signals were also examined, which indicated at least 5 distinct energy pulses within the lahar record.  We infer that varying sediment load and/or changes in flow velocity is shown by clear fluctuations in the acoustic and seismic power recorded at one of the stations. This particular event studied with infrasound provides insight into how lahars occur around Volcán de Fuego.

Satellite radar backscatter has the potential to provide useful information about the progression of volcanic eruptions when optical, ground‐based, or radar phase‐based measurements are limited. However, backscatter changes are complex and challenging to interpret: explosive deposits produce different signals depending on pre‐existing ground cover, radar parameters and eruption characteristics. We use high temporal‐ and spatial‐resolution backscatter imagery to examine the emplacement and alteration of pyroclastic density currents (PDCs), lahar and ash deposits from the June 2018 eruption of Volcán de Fuego, Guatemala, using observatory reports and rainfall gauge data to ground truth our observations. We use a temporally dense time series of backscatter data to reduce noise and extract deposit areas. We observe backscatter changes in six drainages, the largest deposit was 11.9‐km‐long that altered an area of 6.3 normalknormalm2 and had a thickness of 10.5 ±2 m in the lower sections as estimated from radar shadows. The 3 June eruption also produced backscatter signal over an area of 40 normalknormalm2, consistent with reported ashfall. We use transient patterns in backscatter time series to identify nine periods of high lahar activity in a single drainage system between June and October 2018. We find that the characterization of subtle backscatter signals associated with explosive eruptions are best observed with (1) radiometric terrain calibration, (2) speckle correction, and (3) consideration of pre‐existing scattering properties. Our observations demonstrate that SAR backscatter can capture the emplacement and subsequent alteration of a range of explosive deposits, allowing the progression of an explosive eruption to be monitored.

No abstract

No abstract

This study quantified erosional and depositional processes for secondary lahars in Las Lajas drainage at Volcán de Fuego, Guatemala, during the rainy season from May to October 2021. Abundant pyroclastic material from ongoing eruptive activity is remobilized seasonally during heavy precipitation, which can impact infrastructure and populations living near Fuego. Our region of focus was in an agricultural zone 6 to 10 km from the summit, surveyed with an unoccupied aerial vehicle (UAV) quadcopter at monthly intervals. Imagery was processed into overlapping time-lapse structure from motion digital elevation models (DEMs). DEMs were differenced to find volumetric changes as a function of the channel flow path distance (quantified in 500 m sections) to track channel morphology changes over time. The largest measured volume changes were a 490 m3/day loss in the upper section (~6 km from summit) and a 440 m3/day gain in the lower sections (~10 km from summit). We discussed how the natural channel’s constriction and widening of Las Lajas in more distal sections control the behavior and stability of the stream evolution. Above the constriction, the channel is primarily downcutting and meandering within an old flood plain, which had been filled in by pyroclastic materials deposited by the June 2018 paroxysm.